JVC CS-V524AU Car Stereo Speaker Instructions
- June 14, 2024
- JVC
Table of Contents
CAR STEREO SPEAKER
CS-V524
Instructions
CS-V524AU Car Stereo Speaker
For Customer Use:
Enter below the Model No. and Serial No. which is located either on the rear
or bottom of the speaker unit. Retain this information for future reference.
Model No.————
Serial No. ————
LVT1274-001A
Thank you for purchasing the JVC Car Stereo Speakers. These speakers can be mounted either in the doors or in the rear tray of your vehicle. For the secure installation and perfect operation of your speakers, please read the following carefully.
For Proper Installation and Use
- Be sure to install the speakers according to the directions so as to prevent them from slipping accidentally out of position due to the repeated impact ot opening and closing doors or the tossing and bumping of the vehicle.
- Set the wiring firmly on the floor of the vehicle, taking the utmost care not to break wires while installing. When installing the speakers in the doors, extra attention must be paid to allowing reasonable play to the wires. The wiring, if given too much clip or clamp, will get pinched in between the door and body of the vehicle when opening and closing doors.
- Since the speaker installed in the door is posi- tioned at the foot level, be careful not to damage the speaker by giving it an inadvertent kick. Check the water outlet at the bottom of the door occasionally to ensure that it drains well, leaving no rainwater inside the door.
- Before connecting the speakers to the ampli- fier, confirm that the power has been turned off. The click noise generated by the connection if the power is on may damage the speakers.
- The amplifier and speakers should be connected between corresponding terminals, i.e. “left” to “left”, and “right” to “right”, as well as “+” to “+”, and “—” to “—”. Connection with reversed polarity will degrade the quality of stereo reproduction.
- Do not subject the speakers to excessive input. The power handling capacity of the CS-V524 is 180 watts (MAX. MUSIC POWER). Any excessive input may damage the speakers.
- The CS-V524 has an impedance of 4 ohms.Make sure that the output impedance of the amplifier’s speaker terminal is rated at 4 ohms.
- When cleaning the speakers, use a soft cloth and wipe the surface gently. Do not apply thinner or solvent.
How to Install
- To install the speaker in the rear tray, first determine the appropriate area in which to place it. The speakers must be installed in a place where there are spaces of at least 34 mm over the tray and at least 50 mm under the tray. In determining the location, make sure that the bottom part of each speaker fits into the large hole in the steel plate on which the rear tray is fixed. (Fig. 1)
- Remove the rear tray.
- The paper pattern printed on the bottom of the packing box shows the exact shape of the area on the rear tray through which the speaker will be installed. Apply the paper pattern onto the area determined in 1. above, and trace out the shape of the area on the tray.
- Then, cut out the marked area.
- The next step is to wire the speakers. Consult the diagram carefully. (Fig. 5)
- Use the provided tapping screw and speed nuts to fix the speaker and grille to the rear tray. First, remove the metal net from the grille. Align the 4 screw holes of the speaker frame and grille with those in the rear tray, insert the 4 screws and secure them with the nuts. Finally, attach the metal net to the grille (Fig. 2).
- The process for installing the speakers in the door is much the same as for installing the speakers in the rear tray. In this case, however, extra care must be taken to install the speaker out of the way of the door handle. Install the speakers with the terminals down. (Fig. 3 & 4)
| 
---|---
| 
- Metal Net
- Grille
- Screw
- Speaker
- Speed Nut
How to Complete the Wiring
Consult the diagram below. Be sure to connect corresponding terminals, i.e.
“left” to “left”, “—” to “—”_ etc. (Fig. 5)
Dimansions
This file has been downloaded from:
User Manual and User Guide for many equipments like mobile phones, photo
cameras, monther board, monitors, software, tv, dvd, and othes..
Manual users, user manuals, user guide manual, owners manual, instruction
manual, manual owner, manual owner’s, manual guide, manual operation,
operating manual, user’s manual, operating instructions, manual operators,
manual operator, manual product, documentation manual, user maintenance,
brochure, user reference, pdf manual
Specifications
Type: 13 cm (5-1/4″) 2-Way Coaxial Speaker
Power Handling Capacity : 180 watts (MAX. MUSIC POWER) Metal
Impedance : 4 ohms
Magnet Mass: 182g (6.4 oz) Speed
Mass: 0.7 kg (1.6 Ibs) Speake
(Design and specifications are subject to change without notice.)
Accessories
Gill ————— ×2
Metal Net ————— x2
Sorew (Ø 4 x 25 mm) ————— x8
Speed Nut ————— x8
Speaker Code (4 m) ————— ×2
Thank you for purchasing the JVC Car Stereo Speakers. These speakers can be mounted either in the doors or in the rear tray of your vehicle. For the secure installation and perfect operation of your speakers, please read the following carefully.
Downloaded from: https://www.usersmanualguide.com/©2005
Victor Company of Japan, Limited
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>