BORMANN Elite BFN9010 Floor Fan User Manual
- June 4, 2024
- BORMANN Elite
Table of Contents
BORMANN Elite BFN9010 Floor Fan
WARNING: It is important that you read these instructions before using your product and we strongly recommend that you keep them in a safe place for future reference.
Safety Instructions
- Use as per the rating voltage.
- Do not repair or remake the appliance by yourself, it should be repaired by the repairmen.
- Do not operate the appliance with wet hands, in order to avoid damage.
- If the supply cord is damaged, it must be replaced by a same cord from the manufacturer or its service agents.
- When the appliance is not in use, switch it off and unplug it.
- Do not insert things to air outlets and inlets, in order to avoid damage.
- Do not use the appliance near explosive and combustible gas.
- Use the appliance only on a flat surface.
- Do not use outdoors.
- Do no turnover the appliance. Unplug the power supply If it is toppled over and there have some water in the body. Dry the body before use.
- Clean the appearance with a lightly damp cloth. It can clean with neutral detergents. Do not rinse with water.
- Do not make air outlets and inlets near the wall or curtain.
- Do not knock or shake the body when use, otherwise it may cause stop.
- The appliance must not located immediately below a socket outlet. The rating current of socket should exceed 10A.
- Do not use the appliance in the immediate surrounding of a bath ,a show or a swimming pool.
- This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities or lack of experience and knowl-edge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
CAUTION!
-
Incorrect operation and improper use can damage the appliance and cause injury to the user.
-
The appliance may be used only for its intended purpose. No responsibility can be taken for any possible damage caused through incorrect use or improper handling.
-
Before connecting the appliance to the power source, check that the current and
-
Do not put the appliance or the plug in water or any other liquid. If the appliance accidentally falls into water, make sure your hands are dry and unplug the appliance immediately. Discard the appliance once it is safe to do so.
-
Never attempt to open the housing yourself.
-
Do not place any kind of object into the housing.
Do not use the appliance with wet hands, or on a damp floor or when the appliance itself is wet. -
Do not touch the plug with wet or damp hands.
-
Check the power cable and the plug regularly for any possible damage. If the power cable or plug is damaged, it must be replaced by the manufacturer or a qualified person to avoid creating a hazardous situation.
-
Do not use the appliance if it is dropped or otherwise damaged, or if the power cable or plug are damaged.
If the appliance is damaged, take it to the authorised service centre for -
Never attempt to repair the appliance yourself. This could cause an electric shock.
-
Do not allow the power cable to hang over sharp edges. Also keep the power from the mains socket by holding the plug itself.
-
Make sure there is no danger of the power cable or an extension cable being inadvertently pulled or causing anyone to trip when the appliance is in use.
-
If an extension cable is used it must be suited to the consumption of the appliance, otherwise overheating of the extension cable and/or plug may occur.
-
This appliance is not suitable for commercial use nor for use in the open air.
-
Never leave the appliance unattended while it is in use.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
Ensure that the fan is switched off from the supply mains before removing the guard.
Attention:
- Children cannot recognize the dangers associated with incorrect use of electrical appliances. So, never allow children to use household appliances without supervision.
- Always remove the plug from the mains socket when the appliance is not in use and each time before it is cleaned.
- Danger! Nominal voltage is still present in the appliance as long as the appliance is connected to the mains socket.
- Switch the appliance off before disconnecting it from the mains.
- Never use the power cable to carry the appliance. Use handles to carry the appliance.
- Ensure that the mains socket where you plug your fan in corresponds to the voltage specified on the rating label on the base of the appliance.
- This appliance can be used by children aged 8 years and above and persons with reduced physical , sensory or mental capabilities or a lack of experience and knowledge if they have been given supervision or instructions concerning safe use of the appliance and understand the hazards involved.
- Children must not play with the appliance.
- Cleaning and user maintenance must not be carried out by children without supervision.
Technical Data
- Voltage/Frequency: 220-240V~50Hz Power: 100W
- Additional features: Timer, 3 speeds settings
Assembly Instructions
- Remove the screws from the tubes that form the fan base.
- Attach the tubes using the screws aligning the holes (5 -13).
- Finally screw the base to the fan body so that the electrical wires are located on the outside of the base.
Operating instructions
- Place the fan on a dry surface.
- Plug the power cord into the 230V AC outlet.
- Turn on the fan by pressing the “ON/SPEED” button on the control panel.
- Press ,”LOW” button again to set the fan into low speed. Press “MED” button again to set the fan into medium speed.
- Press “HI” button again to set the fan into high speed. Press “SWING” button, the fan will keep swing.
- Press “TIMER” ® button to set time as follows: 0.5H.1H, and up to max 7.5H.the unit will keep working if the timer light is off.
- Turn off the fan by pressing the “OFF” button on the control panel.
Care and storage
- Turn the control to OFF and unplug the fan before cleaning.
- Use only a soft, damp cloth to clean the fan.
- Do not place the fan in water and never allow water to drip into the Motor Housing.
- Do not use gasoline, paint thinner or other chemicals to clean the fan.
- To clean the fan Blade, Remove the Front grill and Wipe the Blade and Grills.
- Reassemble the fan by snapping the Front Grill into place.
- Store the fan in its original box or cover the fan to protect it from dust.
- Store it in a cool, dry place.
Disposal of electrical and electronic equipment
To protect our environment and to recycle the raw materials used as completely
as possible, the consumer is asked to return unserviceable equipment to the
public collection system for electrical and electronic. The symbol of the
crossed indicates that this product must be returned to the collection point
for electronic waste to feed it by recycling the best possible raw material
recycling.
By ensuring this product you will prevent possible negative effects on the
environment and human health, which could otherwise be caused due to improper
disposal of that product. The recycling of materials from this product, you
will help to preserve a healthy environment and natural resources.
- The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
- Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
- To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>