EARTHQUAKE STM6BT 6.5 Inch 2 Way BI Amplified Professional Studio Monitor User Manual
- June 14, 2024
- Earthquake
Table of Contents
STM6BT 6.5 Inch 2 Way BI Amplified Professional Studio Monitor
Product Information
The device with FCC ID 2A7SX-SM6BT complies with part 15 of the
FCC Rules. It has been evaluated to meet general RF exposure
requirements. The device is designed to avoid harmful interference
and accept any interference received, including interference that
may cause undesired operation. Any changes or modifications not
expressly approved by the responsible party for compliance may void`
the user’s authority to operate the equipment.
To maintain compliance with FCC’s RF exposure guidelines, it is
recommended to keep a distance of at least 20 cm between the
radiator of the device and your body during operation and
installation.
Product Usage Instructions
-
Ensure the device is placed at least 20 cm away from your
body. -
Follow the installation instructions provided in the
manual. -
Do not make any changes or modifications to the device without
express approval from the responsible party for compliance. -
Operate the device in accordance with the user manual to avoid
undesired operation. -
If you experience any issues or concerns, refer to the
troubleshooting section of the user manual or contact customer
support.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: –Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver. –Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. –Consult the dealer or an experienced radio/TV
technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. To
maintain compliance with FCC’s RF exposure guidelines, the distance must be at
least 20 cm between the radiator and your body, and fully supported by the
operating and installation
3
3 FC C ID2 A 7 SX – SM 6 BT
3 FC C ID2 A 7 SX – SM 6 BT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>