MATTRESS FIRM Adjustable Bed Base Certified Floor User Guide
- June 15, 2024
- MATTRESS FIRM
Table of Contents
MATTRESS FIRM Adjustable Bed Base Certified Floor
Adjustable Base setup guide
STEP 1
Remove top of shipping carton. Verify contents; inspect for damage.
READ ALL INSTRUCTIONS BEFORE USING
WARNING
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE
BASE.
SETUP
STEP 2
Cut zip-tie from electrical power supply. Cut (2) zip-ties and remove mattress
retainer (set aside) (FIGURE 1).
CAUTION
BE CAREFUL USING SHARP INSTRUMENTS. INJURY IS POSSIBLE IF TOOLS ARE NOT USED
PROPERLY.
STEP 3
Carefully lift base head section out of shipping carton and place on clean
surface (FIGURE 2).
Remove the divider from shipping carton.
Carefully lift base foot section out of shipping carton and place adjacent to
head section (FIGURE 2).
Slide head and foot sections together making sure to align mounting holes
(center of base sections) (FIGURE 2).
WARNING
PINCH POINT WARNING!
KEEP HANDS AND FINGERS CLEAR WHEN SLIDING BASES TOGETHER.
STEP 4
Place a T-Spacer in between the mounting points (each side of base). Line up
the holes in the T-Spacers with the holes in the mounting points (FIGURE 3).
Place a center support bracket over the mounting points on each side of base.
Insert carriage bolts through the square holes in the center support bracket.
Install nuts on carriage bolts (FIGURE 3). HAND TIGHTEN.
After all hardware is installed, tighten all nuts using provided wrench.
STEP 5
Route FOOT MOTOR CABLE underneath base frame and connect to HEAD MOTOR CABLE
(FIGURE 4). 600 MODEL ONLY – Route FOOT MASSAGE MOTOR CABLE underneath base
frame and plug into control box (FIGURE 4). Extend electrical power cord out
head end of base.
WARNING
POWER CORDS MUST NOT INTERFERE WITH ANY ADJUSTABLE BASE MECHANISMS.
STEP 6
Screw (4) legs into the threaded inserts at the corners of the base frame
(FIGURE 5).
Screw (2) legs into the threaded inserts of the center support brackets
(FIGURE 5).
Push pin in to adjust leg height (6 inches to 10 inches).
Note: When adjusting legs, make sure base sets level on floor.
STEP 7
Rotate base over onto its legs. Remove remaining packaging.
WARNING
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE
BASE.
STEP 8
Install (3) batteries in remote control.
Plug power cord into power outlet. Note: An electrical surge protection device
is recommended (not included).
Operate remote control to test base functions (FIGURE 6) (see separate Syncing
Guide).
STEP 9
Lower base to flat position.
STEP 10
Install the mattress retainer at the foot end of the base.
Place one end of the mattress retainer into the outside hole of the left
insert and place the other end into the outside hole of right insert (FIGURE
7).
STEP 11
Place mattress on base to complete assembly.
Note: If adjustable base will not operate, refer to the Troubleshooting
section of the owner’s manual. To download a copy of the owner’s manual, visit
https://lpadjustablebeds.com/om/mattressfirm or call Mattress Firm at
844-628-8376.
To register your adjustable base, please go to
https://lpadjustablebeds.com/register or call Mattress Firm at
844-628-8376.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>