PASCO ME-7020 Motor Mount Instruction Manual
- June 15, 2024
- PASCO
Table of Contents
ME-7020 Motor Mount
Instruction Manual
Introduction
The Motor Mount is a fixture used to connect a PASCO motor, such as the High Speed Stepper Motor (PS-2976), to a PASCO structures set.
Components
Included equipment:
- 2× Motor Mounts
- 2× shaft spline adapters
- 8× 4-40 screws (not pictured)
Required equipment:
- Any of the following PASCO motors:
- High Speed Stepper Motor (PS-2976)
- Low Speed Stepper Motor (PS-2978)
- Servo Motor (SE-2975)
- Continuous Rotation Servo (SE-2977)
Setup
Connect a motor to the Motor Mount
-
Insert a shaft spline adapter onto the spline on the motor, as shown below.
-
Make sure that the four black grommets are attached to the motor, with the flat side facing out, as shown below. If they are not, install them.
-
Slide the shaft spline adapter through one of the large holes on the Motor Mount. Position the motor so the grommets line up with the four small holes in the Motor Mount, as shown in Figure 1.
TIP: Pay attention to which hole is being used, as some experiments may call for the motor to be in a specific orientation. -
Use four 4-40 screws to secure the motor bracket to the motor, as shown in Figure 1.
Connect the Motor Mount to a structure
You can attach the Motor Mount to a connector or full-round connector in a
PASCO structures set. To do this, align the hole in the triangular top of the
Motor Mount with one of the holes in the connector, then insert a screw
(provided with the structures set) into the hole and tighten to secure, as
shown in Figure 2. Note that the triangular top includes a small circular pin
which fits neatly into an indentation on the connector, making it easier to
align and secure the two components.
Technical support
Need more help? Our knowledgeable and friendly Technical Support staff is ready to answer your questions or walk you through any issues.
| Chat | pasco.com |
|---|---|
| Phone | 1-800-772-8700 x1004 (USA) |
+1 916 462 8384 (outside USA)
Email| support@pasco.com
Limited warranty
For a description of the product warranty, see the Warranty and Returns page at www.pasco.com/legal.
Copyright
This document is copyrighted with all rights reserved. Permission is granted
to nonprofit educational institutions for reproduction of any part of this
manual, providing the reproductions are used only in their laboratories and
classrooms, and are not sold for profit. Reproduction under any other
circumstances, without the written consent of PASCO scientific, is prohibited.
Trademarks
PASCO and PASCO scientific are trademarks or registered trademarks of PASCO
scientific, in the United States and in other countries. All other brands,
products, or service names are or may be trademarks or service marks of, and
are used to identify, products or services of, their respective owners. For
more information visit www.pasco.com/legal.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>