GOLD NOTE PST-10 External Power Supply User Manual

GOLD NOTE PST-10 External Power Supply

IMPORTANT SAFETY INFORMATION

PLEASE NOTE

1. Do not disassemble any part of the product.
2. Do not use any part of the product for other purposes.
3. For service and problems of any kind, contact qualified Gold Note personnel.
4. Protect the product from rain, humidity and keep away from heat sources, electric and electronic motors etc. The power cord supplied must be used only on this unit.
5. Gold Note does not have responsibility for any improper use of this unit.

GENERIC INFORMATION

• Read these instructions and store them.

• Heed all warnings.

• Follow the instructions.

• Do not use this apparatus near water.

• Clean only with a dry cloth.

• Do not block the ventilation openings and install in accordance with the manufacturer’s instructions.

• Do not install near heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

• Do not defeat the safety purpose of the polarised or grounding-type plug: a polarised plug hastwo blades with one wider than the other.

• A grounding type plug has two blades and a third grounding prong. The wide blade or third prong are provided for your safety.
  If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

• Only use attachments/accessories specified by the manufacturer.

• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
  When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

• Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel only. Servicing is required when the apparatus has been damaged in any way (such as when the power cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture) and in any case when the apparatus does not operate normally or has been dropped.

CAUTION!
To reduce the risk of electric shock, do not remove cover (or back). No user- serviceable parts inside. Refer only to qualified Gold Note service personnel for service.

WARNING!
To prevent fire or shock hazard, do not expose this appliance to rain or moisture.

GOLD NOTE – Information on the correct management of waste from household Equipment pursuant to the European Directive 2012/19/EU
The crossed-out wheelie bin symbol shown on the equipment or its packaging indicates that the product, at the end of its useful life, must be collected separately from other waste to allow its proper treatment and recycling. The user must therefore deliver, free of charge, the end-of-life equipment to the centres for the separate collection of waste electrical and electronic equipment, or return it to the dealer in accordance with the procedures established by the legislation.

The appropriate separate collection of discarded equipment allows for proper recycling, treatment and environmentally compatible disposal, helping to avoid the possible dispersion of hazardous substances and negative effects on the environment and health, favouring the reuse and/or recycling of the materials of which the equipment is composed of. Illegal dumping of the product by the user involves the application of administrative sanction provided for by the legislation in force. We invite you consult the current legislation and the measures adopted by the public service operating in your country or territory.

PACKAGE CONTENT

• 1x PST-10
• 1x POWER CABLE
• 1x PST-10 LINK CABLE
• 1x USER MANUAL
• 1x TOOL FOR VOLTAGE SELECTION

INTRODUCTION AND FEATURES

The PST-10 is a super inductive power supply designed for Gold Note turntables. It has been engineered with the best quality audio-grade components to enhance the performance of your turntable, improving your analogue setup to get exceptional results.
PST-10 features a dual choke design powered by a double inductor that drives the negative and positive high-current stages, and features an inductive filter on the analogue stage. The dual choke design perfectly filters the signal voltages in order to eliminate all electrical interferences coming from the power grid.

The power is based on 4 transformers, 3 of which are dedicated to the power supply circuits and with 1 for the inductive filter and the chokes. Its massive power supply shields the turntables from electro-magnetic interferences thus insulating them effectively from the AC power grid.
Adding the PST-10 will result in low noise, greater dynamic, better resolution and finer details for a more realistic high-end audio performance and pure audio pleasure.

TECHNICAL SPECIFICATIONS

MAIN FEATURES

• 4 audio grade transformers
• 4 ultra-low noise voltage regulator
• Inductive interference suppression filter
• Maximum variation of output voltage: 0,05%
• Line noise rejection: >80dB
• Common mode noise rejection: >80dB
• Full power response: <2,5μsec

POWER

• Power supply: 100-120V / 220-240V with auto sense, 50/60Hz
• Power consumption: 25W
• Dynamic power: >50W
• Standby power: <1W
• Fuse 0.5A T

DIMENSIONS AND WEIGHT

Dimensions:
200W | 80H | 260D mm
290W | 180H | 390D mm – boxed

Weight:
Kg. 3
Kg. 4 – boxed

FRONT PANEL

FRONT PANEL OVERVIEW
The status LED turns on when the unit is powered and the master switch is set to ON.

1. LED status light
   Blue = ON/Stand-By

REAR PANEL

REAR PANEL OVERVIEW
Use the voltage selector to set the output voltage required by your turntable.

1. PSU Out
2. GND signal ground
3. AC Plug
4. Master switch
5. Voltage rotary switch

SET-UP INSTRUCTIONS

The PST-10 is designed to power Gold Note turntables featuring synchronous 12V motors only.
There are three voltage settings, so the PST- 10 must be correctly set before installing it.
Powering a turntable with the wrong voltage may result in damages to the motor.

PST-10 OUTPUT VOLTAGE SETTING

1. Connect the power cord to the AC outlet.

2. Switch on the master switch on the rear panel of the PST-10.

3. Use the special tool supplied to select the correct voltage by rotating the voltage switch located on the rear panel.
   The selected voltage setting is indicated by the corresponding LED.

4. Now connect the PST-10 to your turntable using the PST link cable supplied.

HOW TO FIND THE CORRECT VOLTAGE FOR YOUR TURNTABLE
To find the correct voltage required by your turntable, check the information printed on the wall-wart originally supplied.
The voltage will be 18V, 26V or 34V.

PRODUCT REGISTRATION

We recommend to register the unit on our internet website within 15 days from the purchase at www.goldnote.it/product-registration
If the unit is not registered correctly or has been purchased from a different country of the purchaser home address the unit will not be covered by any warranty and the registration will be refused.
Please note that the warranty does not cover in any case: Tubes, Phono Cartridge Stylus and Batteries.

www.goldnote.it/product-registration

WARNING
Gold Note products should only be opened, serviced and inspected by certified Gold Note technicians and dealers. Work performed by unqualified personnel may cause serious damage or personal injury. Opening of the product by non- authorised personnel will void the guarantee.
In this case, contact your dealer to be advised on how the fault can be solved.
Do not return any object directly to the factory or to the distributor without being authorised to do so.

WARRANTY
All Gold Note products come with a warranty against defective materials and workmanship.
Any service and inspection must be carried out by a Gold Note dealer or distributor so in case you need any assistance with this product, please contact the seller.

PLEASE NOTE
Descriptions and technical characteristics may vary at any time and without notice.

TROUBLESHOOTING

CLEANING THE UNIT
With EXTREME care use ONLY water or detergents for delicate surfaces with a very soft cloth to sweep dust and remove stains.
Any acid or not extremely soft cloth will irreversibly damage the unit fine aesthetic. Do not use alcohol.

RELATED PRODUCTS

TUSCANY
External power supplies dedicated to the 1000 Line of electronics to enhance musical realism, staging and deliver even finer details.

MACHIAVELLI
A low output MC cartridge that delivers a fantastic dynamic range and tonal balance, the perfect tool to extract the finest details from your records.

DONATELLO
Lightweight MC phono cartridge with top-of-the-range performance. Features Micro Elliptical diamonds, copper coils and Duraluminium body.

PHONO STAGES

PH-1000
The PH-1000 is a fully analogue phono preamplifier featuring limitless EQ Curves, a high-quality Class-A line stage, headphone output and much more. All controlled through the intuitive display and SKC (Single Knob Control) technology.

PH-10
The PH-10 is a fully analogue phono preamplifier that offers unique features, including EQ CURVES, LOAD and GAIN adjustments, and an intuitive UX thanks to its SKC (Single Knob Control) and display.

Discover more on our website www.goldnote.it

References

• Home | Gold Note
• Product registration | Gold Note
• Produktregistrierung | goldnote
• Registrazione prodotto | goldnote
• Home | Gold Note

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>