BebeStars Galaxy 438-05 Montessori Bed User Manual
- June 13, 2024
- BebeStars
Table of Contents
BebeStars Galaxy 438-05 Montessori Bed
PARTS LIST
ASSEMBLY INSTRUCTIONS
COMPLETED BED
SAFETY WARNINGS
IMPORTANT, KEEP FOR FUTURE REFERENCE-READ CAREFULLY
- The instructions for use should be followed to the letter, so as not to reduce the level of safety of the product.
- WARNING! Do not forget about the risk of fire when the bed is near the fireplace or other sources of fire, such as electric hobs and gas stoves.
- WARNING! It should not be placed too close to other furniture or windows, but almost glued to a wall or at a distance of 30cm. between the wall and one side of the bed.
- WARNING! Do not leave anything in the bed, or place it near another object that could act as a footrest or cause strangulation or suffocation. For example ropes, blinds or curtains, etc.
- WARNING! Do not use the bed if parts are missing or damaged, and use only spare parts approved by the manufacturer. The width and length are predetermined, as it is important that the gaps between the mattress and the sides do not exceed 3cm. This is to minimize the risk of the child being trapped in a vacuum.
- WARNING! Do not use more than one mattress on the cot. Use only a manufacturer- approved bed mattress and make sure that the gap on the sides does not exceed 3cm.
- The mattress to be used must have dimensions proportional to the technical specifications of the manufacturer. The minimum size of the mattress must be 160x80cm. Be aware that there shall be no gap more than 30mm between the mattress and the sides end ends in any position of the mattress.
- The mattress to be used must have dimensions proportional to the technical specifications of the manufacturer. The minimum size of the mattress must be 160x80cm. Be aware that there shall be no gap more than 30mm between the mattress and the sides end ends in any position of the mattress.
- All connections must be tightened properly, checked regularly and tightened again when needed. Screws and bolts should not be loose as a child may squeeze parts of the body or climb on their clothes (eg laces, necklaces, baby doll ribbons, etc.). There is a risk of strangulation.
- The bed should only be used on a dry, stable and flat surface away from electrical outlets.
- If you leave the child unattended in the bed, always make sure that any folding parts of it are locked.
- Never move the bed while the child is inside.
- Maximum load weight: 60 kgs.
- Mattress is not included.
CARE & CLEANING
- Your furniture can be cleaned by wiping with a damp cloth and drying with a so clean cloth.
- Do not use abrasives, bleach, alchohol or ammonia based household polishes.
- Take care when handling or moving. Careless handling can damage wooden furniture.
ASSEMBLY INSTRUCTIONS
-
Insert D into 6,7 and 8, and then connect 6, 7 and 8 with 1 and 2 with A and B.
In the same operation, connect another 6, 7 and 8 with 1 and 3. -
Insert D into 9, and then connect 5 and 9 with two bed heads with A and B.
-
A. Connect 4 with two bed heads with 2 A and 2 B.
B. Fix 11 to 4 with G.
C. Connect 10 with 1 and 11 with 4 A and 4 B, 2 Cand 2 B separately. -
After crossing 12, connect it with 13 with A and B, and then fix it on the bed leg with E.
After laying the bed board on the edge of the bed, fix it with F. -
Screw H into 15 and insert I into 17, 18, 19 and 21. When H is inserted into the corresponding holes of 17, 18, 19 and 21, tighten I.
-
Insert 20 into the chute and insert N in the middle to connect.
-
Install 16 with F and install wheels with J.
Thank you for choosing Bebe Stars products
CONTACT
- bebestarsbygilis
- @bebe.stars
- bebestarsbygilis
- 63200 | Nea Moudania | Greece
- www.bebestars.gr.