BebeStars 4220 2in1 Fun Park Baby Walker User Manual
- June 12, 2024
- BebeStars
Table of Contents
User’s Manual
Baby walker 2in1
Fun park
Item 4220 / 4221 (805)
Standards:
EN 1273
EN 71
4220 2in1 Fun Park Baby Walker
Your child’s safety depends on you. Proper usage cannot be assured unless you
follow these instruc
DO NOT USE THIS PRODUCT UNTIL YOU READ AND UNDERSTAND THESE INSTRUCTIONS
SAFETY GUIDE
Read the instructions carefully before use and save for future reference.
The child may be injured if you do not follow these instructions.
- It is intended for children aged about 6 months and up who can sit on their own without assistance. Not intended for children who can walk or weigh more than 12kg.
- Do not place any load on the walker that could affect stability. The maximum load of the walker is 12kg.
- Warning: Avoid access to stairs, steps and non-flat surfaces.
- Warning: The child may move quickly and move away when using the walker.
- Avoid access to fireplaces, heaters and cookers.
- Avoid access to hot liquids, electrical cables and other potential hazards.
- Prevent collisions with glass doors, glass balcony doors and furniture.
- Do not move the walker while the baby is inside.
- Do not use the walker if any of its parts are broken or missing.
- Keep the plastic cover away from the baby, there is a risk of suffocation, etc.
- The walker should only be used for a short time (eg 20 ‘).
- When using a walker, the child should step on both feet.
- Adjust the height of the position appropriately to prevent falls or injuries.
- Do not use spare parts that are not approved by the manufacturer or distributor.
- Small pieces should only be assembled by adults.
WARNING !!!
Never leave your child unattended!
BATTERY INFORMATION
CAUTION
Non-rechargeable batteries must not be recharged.
Rechargeable batteries must be removed from the toy before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Different type of batteries or new and used batteries must not be mixed.
Only batteries of the same type as recommended are to be used, alcaline AA
1.5V.
Batteries must be inserted with the correct polarity.
Exhausted batteries must be removed from the toy.
Toy tray should be put onto the top tray when the baby stays in the walker.
Batteries should be removed if the product is not going to be used in a short
while
Batteries not included
PARTS LIST
1. Seat
2. Toy tray
3. Height adjustment
4. Main frame
5.Tilt adjustment| 6.Bumber
7. Speed adjustment
8. Anpads
9. Wheel
---|---
INSTALLATION
Insert the legs in the corresponding holes on the base and adjust the height with the (A) buon.
Install the bumber when in walker mode. Remove when in pusher mode.
Clamp the seat on the corresponding holes on the main frame.
Install the toy bar on the main toy tray and place the tray on the main frame of the walker.
INSTRUCTIONS OF USE
Use the strap on the seat to adjust the height of the crotch.
Use the speed adjustment wheel (D) to reduce or increase the speed of the walker.
Pusher mode
Remove the bumber before converng to pusher mode.
- Push the adjustment buons on both sides of the walker.
- Tilt the seat as shown in the picture unit locks in place.
Pusher mode
CARE & MAINTENANCE
- Please check on a regular basis that the latches, connecelements, belt systems and seams are properly func
- Care for, clean and check this product regularly.
- Clean with a damp sponge or cloth and mild detergent.
- Do not use abrasives or bleach.
Thank you for choosing Bebe Stars products
FOLLOW US
www.bebestars.gr
| 
---|---
<https://www.bebestars.gr/?s=4220>|
<https://www.bebestars.gr/?s=4221> | bebestarsbygilis
---|---
| @bebe.stars
| bebestarsbygilis
| 63200 | Nea Moudania | Greece
Documents / Resources
|
BebeStars 4220 2in1 Fun Park Baby
Walker
[pdf] User Manual
4220, 4221 805, 4220 2in1 Fun Park Baby Walker, 2in1 Fun Park Baby Walker, Fun
Park Baby Walker, Baby Walker
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>