BebeStars 4218, 4219 Baby Walker 2 in 1 Robot, Galaxy User Manual
- June 12, 2024
- BebeStars
Table of Contents
BebeStars 4218, 4219 Baby Walker 2 in 1 Robot, Galaxy User Manual
PARTS LIST
- Seat
- Toy tray
- Suspenders
- Main frame
- Handrail
- Height adjustment button
- Bumber
- Speed adjustment wheel
- Wheels
- Anti-slip pads
ASSEMBLY INSTRUCTION
INSTRUCTION FOR USE
PUSHER MODE
SAFETY INSTRUCTION
Read the instructions carefully before use and save for future reference. The child may be injured if you do not follow these instructions.
- ltisintended for children aged about 6 months and up who can sit on their own without assistance. Not intended for children who can walk or weigh more than12kg.
- Donotplace anyload on the walker that could affect stability. The maximum load ofthe walkeris 12kg.
- Warning: Avoid access to stairs, steps and non-flat surfaces.
- Warning: The child may move quickly and move away when using the walker.
- Avoidaccessto fireplaces, heaters and cookers.
- Avoid access to hot liquids, electrical cables and other potential hazards.
- Prevent collisions with glass doors, glass balcony doors and furniture.
- Donotmove the walker while the baby is inside.
- Donot use the walker if any of its parts are broken or missing.
- Keep the plastic cover away from the baby, there is a risk of suffocation, etc.
- The walker should only be used forashorttime (eg 20″).
- When using awalker, the child should step on both feet.
- Adjust the height of the position appropriately to prevent falls or injuries.
- Donotusespare parts thatare not approved by the manufacturer or distributor.
- Small pieces should only be assembled by adults.
WARNING !!!
Never leave your child unattended!
ASSEMBLY INSTRUCTIONS
- Raise the suspenders on upright position. (Figure 1)
- Raise the inner suspenders. (Figure 2)
- Hold and rotate the seat panel on upright position. (Figure 3)
- Push the seat panel down to lockin place. (Figure 4)
- Install the seat. (Figure 5)
- Install the backrest. (Figure 6)
- Install the bumber. (Figure 7)
- Install the toy tray. (Figure 8)
INSTRUCTIONS FOR USE
- Lift the height adjustment button as Figure A shows and lift or raise the seat panel as Figure B shows until it locks in your desired position. 3 positions available.
- Use the strap on the seat to adjust the height of the crotch. (Figure C)
- Use the speed adjustment wheel as Figure D shows to reduce or increase the speed ofthewalker.
- To fold the walker, lift both height adjustment buttons, lift the seat and rotate towards frontas shown in Figure E.
PUSHER MODE
- Remove the bumper before converting to pusher mode.
CARE & MAINTENANCE
- Please check on a regular basis that the latches, connecting elements, belt systems and seams are properly functional.
- Carefor, clean and check this product regularly.
- Clean with a damp sponge or cloth and mild detergent.
- Do not use abrasives or bleach.
BATTERY INFORMATION
CAUTION
Non-rechargeable batteries must not be recharged. Rechargeable batteries must
be removed from the toy before being charged. Rechargeable batteries are only
to be charged under adult supervision. Different type of batteries or new and
used batteries must not be mixed. Only batteries of the same type as
recommended are to be used, alcaline AA 1.5V. Batteries must be inserted with
the correct polarity. Exhausted batteries must be removed from the toy.
Toy tray should be put onto the top tray when the baby stays in the walker.
Batteries should be removed if the product is not going to be used ina short while. Batteries notincluded.
Costumer Support
Thank you for choosing Bebe Stars products
FOLLOW US
http://www.bebestars.gr/
bebestarsbygilis
@bebe.stars
bebestarsbygilis
63200 | Nea Moudania | Greece
