WebstaurantStore JD16KIT Aluminum Stock Pot Owner’s Manual

: June 13, 2024
: WebstaurantStore

Table of Contents

Operating Instructions
Assembly Instructions
Instructions
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

WebstaurantStore JD16KIT Aluminum Stock Pot Owner’s Manual

Operating Instructions

Heavy Duty welded Coated Steel Frame
30 Quart Aluminum Stock Pot with Lid
Steamer Basket
10 Quart Aluminum Fish Fryer Pan & Strainer Basket with Heat-Resistant Handle
5 PSI CSA Certified Regulator with Hose
54000 BTU cast iron burner
Poultry Rack & Rack Lifter
1 OZ. Marinade Injector
12” Probe Thermometer

For Outdoor Use Only
Read all Warnings and Operating Instructions before use and retain for future reference.

WARNING: Propane gas is highly flammable and under pressure in the cylinder or tank.
Do Not store or use gasoline or other flammable liquids or vapors in the vicinity of this stove. If you detect the odor of gas, immediately evacuate the enclosed area and contact the appropriate authorities/professionals.

CAUTION
DO NOT attempt to connect your camp stove to a natural gas supply. Use only with propane, hose and regulator supplied with the stove and an approved bulk propane tank.

DANGER
Danger Icon
FOR YOUR SAFETY
Do not store or use gasoline or other liquids with flammable vapors in the vicinity of this or any other appliance.

IF YOU SMELL GAS:

Do Not attempt to light appliance.
Extinguish any open flame.
Disconnect from fuel supply.

Support Hours
24 Hours available

Please have your order number before .
Contacting customer support .

Assembly Instructions

TOOLS NEEDED FOR ASSEMBLY

Adjustable Wrench

INSTRUCTIONS

Unscrew the pre-assembled lock nut and flange nut from the threaded pin of the cast iron burner . Then insert the threaded pin of burner through the hole of the support bar of stove stand.
Insert the heat shield onto threaded pin of the burner then screw with a M6 flange nut and a M6 lock nut.
- Make sure all hardware are used and wrench tighten.

Instructions

PREPARATION：

Place stove on a level, stable surface.
Attach propane hose to the brass stove inlet fitting.
Make sure propane bulk tank valve is closed.
Attach propane hose to outlet of propane tank.
Slowly open propane tank valve and check for leaks by applying small amount of liquid soap and looking for bubbles to appear.

Note: When connecting the Hose to unit, insert the male fitting of the hose. Tighten the fitting onto the throat of the burner using a wrench.
Do not overtighten. You should be able to turn the air control panel.

LIGHTING INSTRUCTIONS

Read instruction before lighting.
When you are sure there are no leaks, turn cylinder valve and regulator control valve on hose to the closed position.
Have a fireplace match or long-nosed lighter lit and over the burner from SIDE. Keep hands and face away from burner.
Slowly open gas supply until burner ignites, keeping hands and face away from burner.
Adjust the regulator control valve for desired flame height.
When finished using the cooker, turn off gas cylinder valve first. lt will take a few secondfor the fire to go out and for the propane gas to bleed from the hose and regulator assembly. After the fire is completely out, turn regulator control valve to the OFF position.
To re-light, repeat steps 1-6. Always use CAUTION as cooker will be hot.
If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.

STORAGE

DO NOT leave propane tank attached to stove during storage or transport.
Wipe the burners, steel cooking grate, and propane hose before storing.
It is suggested to store stove and hose in a nylon storage bag to keep it clean.

CAUTION
DO NOT attempt to connect your camp stove to a natural gas supply. Use only with propane, hose and regulator supplied with the stove and an approved bulk propane tank.

Counter clockwise to open the gas supply