IP-COM F1110P-8-102W 2 Gigabit Desktop Switch User Manual
- June 13, 2024
- IP-COM
Table of Contents
IP-COM F1110P-8-102W 2 Gigabit Desktop Switch
Package Contents
- Switch * 1
- Power adapter*1
- User Manual *A
If any item is incorrect, missing, or damaged, please keep the original package and contact the vendor for replacement immediately
Product Overview
Application
LED Indicators
Ports, Switch, Interfaces
Тір:
- In Extend state, please use a CAT5E Ethernet cable or better, and make sure that the rate of the other device is set to Auto-negotiation
- In Default or Vlan state, if you use a CATE Ethernet cable or better, the PoE data transmission distance is up to 150m.
Specifications
CE Mark Warning
- There can notes set toques this suma aust rose
- For Pluggable Equipment, the socket outlet shall be installed near the equipment and shall be easily accessible.
WARNING: The mains plug is used as a disconnect device, the disconnect device shall remain readily operable
- Adapter Model: BN038-A10151
- Manufacturer: SHENZHEN HEWEISHUN NETWORK TECHNOLOGY CO., LTD
- Input: 100-240V-, 50/60Hz 1.6A Output: 51Vdc, 2A ==: DC Voltage
RECYCLING
- This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment
- User has the choice to give their product to a competent recycling organization or to the retailer when he buys new electrical or electronic equipment.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution : Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
- To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
Technical Support
- Address: Room 101, Unit A, First Floor, Tower E3, No. 1001, Zhongshanyuan Road, Nanshan District, Shenzhen, China. 518052
- Tel: (86 755) 2765 3089
- E-mail: info@ip-com.com.cn
- Website: http://www.ip-com.com.cn
Copyright
© 2016 IP-COM Networks Co., Ltd. All rights reserved.
To improvementarian isi operatural uncion, and or tet sir. aim resees tre grin
mang changes to the products described in this document without obligation to
notify any person or organization of such revisions or changes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>