Plastica SSW PUMP 02 Sealed Air Instapac Machine Instructions
- June 13, 2024
- Plastica
Table of Contents
Safe System of Work
OPERATING AND SAFETY INSTRUCTION FOR SEALED AIR INSTAPAC MACHINE
SSW PUMP 02 Sealed Air Instapac Machine
Name: …………………………………………….…………. Training Date:…..…………………………
| Instruction| Understood ✓ or X
---|---|---
1| Ensure all PPE supplied is worn when using this machine. Eye protection
must always be used, NO EXCEPTIONS.|
2| Familiarise yourself with the controls and ensure you know how to operate
the controls correctly. If you are not sure, ask your Supervisor.|
3| Chemical drums are heavy and must only be moved following manual handling
procedures.|
4| On completion of production moulds and vacuum table must be cleaned as per
your training.|
5| DO NOT USE MACHINE unless trained and authorised to do so by your
Manager/Supervisor.|
6| Switch on the wall mounted unit.|
7| Allow warm up cycle to finish. Check level indicators and only commence
product if product is available.|
8| Select correct moulds for the pumps to be built.|
9| Switch on dual speed vacuum unit to required power setting.|
10| Cut approximately 1 metre of instamate 90 film. Film can only be used on
1 side as indicated.|
11| Place the film in mould to achieve best result, using levers to achieve
suck/blow.|
12| Place correct amount of foam from gun into the mould. Cover with film and
close the lid. Tighten both latches.|
13| Wait until the foam sets. Undo the latches, reverse levers to remove the
foam from the mould.|
14| Use trimming tool to neaten edges.|
15| Repeat the process until the total amount on the works order is complete.|
16| Using the scraper provided, clean the moulds and boxes to best result.|
I have received the above training and fully understand every point that was
explained to me. I confirm that I will wear the required PPE equipment when
using the above machinery and take all steps to ensure my own safety. I will
ask for further training if I need to and will immediately inform the
Supervisor or Manager if there are any issues with the machinery.
Name: ………………………………………………………………………………………………………….
Signed: ……………………………………………………………….. Date:…………………………………
I confirm that I have trained the aforementioned person and that they fully
understand how to use the above machinery, have received the required PPE
equipment and know to inform me immediately of any issues with the machinery
or if they require further training. I authorise this person to use the
machinery detailed above.
Name: …………………………………………………………………….……………(Authorised Trainer)
Signed …………………………………………………………………… Date: ……………………………
SSW PUMP 02 – 04/04/18
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>