2007-08 Jeep Wrangler JK Neoprene Rear Seat Covers 2 Door Rear Seats Instruction Manual
- June 13, 2024
- JK Neoprene
Table of Contents
2007-08 Jeep Wrangler JK Neoprene Rear Seat Covers 2 Door Rear Seats
Parts included
- (1) Rear top cover
- (1) Rear bottom cover
- (2) Head Rest Covers
NOTE: Please read the instructions before installing
Installation Instructions
- Step (1): Remove rear headrest from seat. The headrest can be removed by pressing the two buttons located on the top of the seat.
- Step (2): Slip upper seat cover over rear seat. Note location of headrest mounting holes.
- Slip lower Velcro strip between the upper and lower portions of the seat and secure. Connect zipper and close.
- Step (3): Push seat cover over headrest mounting plates. Secure under plastic caps as shown.
- Step (4): Adjust upper seat cover as needed for proper fitment.
- Step (5): Slip lower cover over seat bottom and slide back clips and straps through the gap between the top section and the lower seat section.
- Fold and touble the seat so that front to rear straps can be secured.
- Step (6): With seat folded forward loosen staps and attach front strap to back clip. Repeat for all three locations.
- Step (7): With straps attached carefully pull straps to thighten.
- NOTE: DO NOT OVER TIGHTEN Damage to seat cover may result.
- Step (8): Slide side clips between the seat and the fenderwell and secure. Fold seat back down and check fitment of cover noting carseat attachment slots. Adjust as needed.
- Step (9): Slide supplied headrest covers over headrest and secure velcro.
- Adjust fitment as needed.
- Step (10): Insert headrest back onto rear seat.
- Step (11): Inspect seat cover and adjust as needed. You may need to fold and tumble the seat several times and adjust to get the final fitment.
Contact
- 460 HORIZON DR. SUITE 400 SUWANEE, GA 30024
- PHONE: 770-614-6101
- FAX: 770-614-6069
- info@omix-ada.com
References
Read User Manual Online (PDF format)
Loading......