STEEL GREEN SG36 Parking Brake Cable Replacement Instruction Manual
- June 13, 2024
- STEEL GREEN
Table of Contents
STEEL GREEN SG36 Parking Brake Cable Replacement
REPLACEMENT INSTRUCTIONS
PARKING BRAKE CABLE REPLACEMENT INSTRUCTIONS
NOTE: Instructions are the same for both sides.
STEP ONE:
- Loosen the lug nuts and remove the rear tire.
NOTE:
- The orientation of the cables from side to side, cross from left to right, and right to left.
- Depending on the machine the wheel motor bracket and cable support brackets will be on the outside of the frame.
STEP TWO:
- Be sure the parking pedal is in the “UP” position to release the tension on the springs.
- SG36 Unfasten the clevis to disconnect the cable from the pedal.
- SG52 Unfasten the clevis to disconnect the cable from the wheel motor bracket.
STEP THREE:
- SG36 Loosen the adjustment nuts to free the cable from the bracket.
- SG52 Loosen the adjustment nuts to free the cable from the support bracket.
STEP FOUR:
- SG36 Unfasten the clevis to disconnect the other end of the cable from the wheel motor bracket.
- ASSY. TIP: The brake pedal on the SG52 unit can now be placed in the down position for easier access to the cables.
- SG52 Disconnect the clevis from the pedal.
- Loosen the adjustment nuts to free the cable from the bracket.
- STEP FIVE: Loosen the adjustment nuts to free the cable from the support bracket.
NEW CABLE INSTALATION
NOTE: Repeat this step for the other end of the cable, (2) cables.
STEP ONE:
- Attach the clevis (2447K110) to parking brake cable (D71018).
- NOTE: Instructions are the same for right and left sides..
STEP TWO:
- SG36 Attach one end of the cable to the support bracket.
- SG52 Attach one end of the cable to the brake pedal support bracket on the RIGHT SIDE.
- Attach the clevis to the hole in the brake pedal.
STEP THREE:
- SG36
- Route the cable along the cross member away from moving parts to the opposite side (Fig 1).
- Attach the other end of the cable to the brake pedal support bracket on the RIGHT SIDE.
- Attach the clevis to the hole in the brake pedal.
- SG52
- Attach the other end of the cable to the LEFT side support bracket.
- Attach the clevis to the hole in the wheel motor bracket.
STEP FOUR:
- SG36 Attach The clevis to the wheel motor bracket.
STEP FIVE:
- Neatly zip tie both cables to the frame cross member.
CABLE ADJUSTMENT SG36/SG52
- With the brake pedal in the “UP POSITION” (Fig. 2), adjust the brake cable until the wheel motor bracket is straight (Fig.3).
- Repeat this step for the RIGHT side.
- Reattach the rear tires.
MANUAL PART NO. | MANUAL REV. | DESCRIPTION |
---|---|---|
SGM-030 | B | SG PARKING BRAKE CABLE REPLACEMENT |
PARKING BRAKE CABLE REPLACEMENT
- Models: SG36, SG42, SG46, & SG52
CONTACT
- Steel Green Mfg.
- 824 S State Road 39
- Lebanon, IN 46052
- (765)-481-2890
- www.steelgreenmfg.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>