Woodchuckers ON M1B 3L6 416 Cheese Slicer Kit Instructions
- June 13, 2024
- Woodchuckers
Table of Contents
Woodchuckers ON M1B 3L6 416 Cheese Slicer Kit
Cheese Slicer Instructions
Basic
The cheese-slicing kit can be made with almost any material; Hardwoods,
bamboo, and polymers. We have a selection of hardwood available at the store.
Give us a call. The instructions are for a 3/4″ board, if your board is a
different thickness you will need to account for that. Layout for drilling and
cutting is critical so that the “good” side of the handle is up. We recommend
that your board be 5 3/4″ wide by 9 1/2″ long. If you use a different size you
need to keep that in mind when cutting and drilling.
Cutting & Drilling
Place the board’s good side up on your work surface. The hole for the hardware
will be 1⁄4″ in diameter. Centered on the 3 ⁄4″ thick board 5″ from the right
front of the board. Drill 3 7 ⁄8″ deep. This will center the hole to any size
board. The saw kerf will be 3″ from the right side of the board. Cut a 3 ⁄8″
deep slot. You can use a standard blade, but you could also use a thinner kerf
blade for this project. Clearly marking the saw kerf line on the board so that
when moving to the table saw, the orientation does not get reversed
Cutting Wire Replacement Instructions
- Position the slicer on a flat surface.
- Loosen the screw and turn the handle upward to the left, as shown in the picture
- Using a narrow object (such as a nail), push the wire fastening pinout.
- While holding the base, grasp the metal bar and gently slide it outward until it clears the cutting slot.
- Remove broken wire pieces.
- Take the new wire and place the wire loop into the cutting slot. Slide the bar back into the base passing the bar through the wire loop
- With the handle in the raised position as shown in the picture, place the other wire loop into the handle cavity and reinsert the fastening pin passing it through the loop.
- Turn the handle to the right until it lines up with the hole in the bar. Grasp the handle and tighten the screw into the metal bar.
- Gently work the bar either into or out of the base until the wire is aligned with the cutting slot.
- 50 Venture Dr #4,
- Scarborough,
- ON M1B 3L6 416 – 241-8654
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>