Woodchuckers PKSHOTxx Slingshot Kit Owner’s Manual
- June 13, 2024
- Woodchuckers
Table of Contents
Woodchuckers PKSHOTxx Slingshot Kit
Kit Features
- Easy to Turn
- Minimal Parts–easy to assemble
- Available in multiple finishes
- Replacement Bands (#PKSHOTX) and Packs of Balls (#PKSHOT15) available
- Includes 15 balls
Required Accessories
- Drill Bit: 1 /2″ #PKDB12
- 4 Prong Headstock Center
- Live 60° Tailstock
- 2 part Epoxy (CA not recommended)
- Pen Blank Minimum Size: 1″ x 1″ x 4″L
Preparing the Blank
- Cut blank to desired length to be comfortable in hand. Be sure to add extra material to form a support stock to be parted off later.
- Drill 1/2″ hole lengthwise into one end of the blank to a minimum depth of 2- 9/16″. This will give room for post to be glued. A tighter fit requiring no glue can be done with 15/32″ drill bit-Note that this would require twisting 2-1/2″ of the post into the finished blank by hand.
DIAGRAM B / TURNING THE BLANK
Torning the Blank:
- Mount lathe centers and blank according to diagram B.
- Slide the Tailstock up snugly against the opening in handle, inserting the live center point into the hole.
- Lock Tailstock and hand tighten the quill adjustment with wheel to steady the blank. Do not over-tighten, it could split the blank.
- Using sharp tools, turn the barrel straight or to a profile of your choice. The bottom of the yolk has a diameter of . 795″ use calipers to make an exact match or make slightly larger and round the end to blend with the Yoke parts.
- Reduce the support stock as small as possible before sanding and finishing.
- Sand the blank smooth, gradually increasing sandpaper grits.
- Finish the barrel using your choice of polish. Allow sufficient time for the polish to cure-refer to polish manufacturer’s instructions.
- Part the handle off of the support stock-be prepared to catch the handle as the support is removed. Hand sand and finish the remaining portion where the support stock was.
Assembly
- Thread Post into bottom of Yoke. Insert post into handle, test the fit to make sure the hole is deep enough that there is no gap.
- Mix a moderate amount of 2 part epoxy and spread inside hole in handle and along threads in Post.
- Slide Post into hole. You may wish to clamp or wrap handle and yoke together while glue cures.
- Once epoxy is cured, Slingshot is ready to use.
- Place one of the foam balls provided into the leather pouch, we found the best release was achieved gripping the ball directly from top and bottom as opposed to holding through the leather pouch. Pull back, aim, and release.
- Warning! Never aim towards people or animals. Please use responsibly.
© 2021 PSI Woodworking Philadelphia PA 19115 – v02/22
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>