KLIM Technologies 20230630 Speaker Portable CD Player User Manual

USER MANUAL
MANUEL D’UTILISATION
Speaker
High-Fidelity Sound Reproduction

|
---|---

IMPORTANT SAFETY INSTRUCTIONS

Please read this manual carefully before using this player and keep it for later reference.

THE CD PLAYER

1. If the player fails to work, please contact our customer support team on support@klimtechnologies.com, our staff will be happy to resolve your problems. Remember that the KLIM Speaker is supported by our warranty.
2. The device cannot be used or stored in moist environments. Keep the device away from any liquid, steam, etc.
3. Do not place any liquid or unintended objects other than CDs into the player.
4. Do not expose the device to sunlight over long periods of time and keep it away from heaters. The player is not intended to be stored or used in high temperature environments.
5. All professionals with extensive electronic knowledge and maintenance experience are allowed to disassemble the player for maintenance. The replacement of spare parts must be done in strict accordance with the parameters of the circuit design.
6. Do not scratch or hit the player with sharp objects.
7. There are light emitting diodes in this device. Do not look directly into the lens; such exposure may cause permanent eye damage.
8. Children under the age of 12 should be supervised by an adult when using this device.

BATTERY

Do not disassemble the device or charge the device with power adapters that do not meet the electrical parameters of this product to avoid permanent damage. For your safety, please handle the built-in highcapacity polymer lithium battery by following the instructions below:

1. Do not remove the battery pack.
2. Do not drop or expose the device to any physical impact.
3. Do not short circuit or pierce the battery.
4. Do not place the player under ambient temperatures above 131°F (55°C).
5. Do not put the battery in a fire.
6. If the battery has been damaged, ask a professional to replace the battery with the same specifications, or contact our customer support team.

HEARING SAFETY WARNINGS

Adjust the volume to an appropriate level. If the volume is too high, it may damage your hearing or even cause permanent damage. You should increase the volume slowly, until a comfortable, clear sound can be heard.
Listening to an audio device, even at a reasonable volume, may cause hearing damage if done for extended periods of time. Please use the device in moderation and allow for adequate rest for your ears.

PACKAGE CONTENTS & PRODUCT DIAGRAM

TECHNICAL SPECIFICATIONS

– 20 KHz
Charging Voltage| DC 5V/1A| Earphone Power Output| 16 mW / 16-320 ohm
Operating Voltage| 3.7 V| Earpohone Impedance| 32 ohm/16 mW
Power Consumption| 1.5 W Nominal| Supported Disc Formats| CD, CDR, HDCD, MP3
Battery| Lithium-ion polymer 3.7V/1400 mAh| Shockproof Time| CD: 40-100 seconds
Mp3: 120-180

CONTACT AND TROUBLESHOOTING

Please refer to page 7 for common issues and solutions when operating the KLIM Speaker. In case you require additional assistance or have any questions, please write us directly to our email address at support@klimtechnologies.com.

FIRST USE

HOW TO INSERT A DISC

Push the OPEN button on the right to open the cover. Before first use, remove the protective cardboard to reveal the lens. Insert your index finger into the center hole of the disc and take the edge of the disc with your thumb. Keep the labeled side upward while inserting the disc into CD player and press the disc gently to lock it in place.
Close the disc cover completely, otherwise the player will not read the disc.
To remove an inserted disc, gently pull it upwards from the side.
Note : The player is only compatible with CD, CDR, Mp3, HDCD formats.

USING A TF CARD

After inserting a TF card into the corresponding slot, press and hold the button to enter TF card playback mode.
NOTE : The TF card slot only supports cards up to 32GB of capacity.

USING EARPHONES

Only earphones with a 3.5 mm jack are compatible with this device. In order to experience the best sound quality, please use the included KLIM Fusion or similar high fidelity headphones.

HOW TO TURN ON THE PLAYER
The power switch is located on the side. Slide it to the ON position to play normally. When the last track on a CD is played or there is no CD in the device, the player will enter standby mode after 20 seconds. Press the button again to restart the player. HOW TO TURN OFF THE PLAYER

There are two ways to turn off the player:

1. Move the power switch to the OFF position if the player will not be used for an extended period of time.
2. The player will enter standby mode by pressing the button twice in succession. On standby, the player will continue to consume some power, since it is not completely switched off.
   IMPORTANT : while on standby mode, press the button to reactivate the player.

CHARGING THE PLAYER

This product is equipped with one charging cable. You can use any charger that supports USB 2.0 protocol or standard USB charger to charge the player.
NOTE : Once the battery becomes too low, a flashing battery indicator will appear on the display.

Charging time: It takes around 3-4 hours to fully charge the player (this varies depending on the power output). When the battery is being charged, the LED indicator is red. Once the player is fully charged, the LED indicator will turn green.

PLAYBACK OPTIONS

Each time the MODE button is pressed, the order of the tracks played will be as follows: Repeat current track (REP1), DIR (Folder read), Repeat all (ALL), Shuffle (SHUF), preview play (INTRO (first 10 seconds of a track).

SAVING TRACK PRESETS

1. Press to stop all playback.
2.  Press to enter programming mode.
3. Press to select the track you want to save, then press PROG to save it.
4. Repeat step 3 until you have assigned all the tracks. You can assign up to 30 tracks.
5. Press while in programming mode to start playing your track selection.
   To exit programming mode, press the button.

NOTE : the preselection is not stored in memory. Once you leave the programming mode, you’ll need to reprogram all tracks again.

LAST MEMORY

ON: The player will return to the last played track on the CD.
OFF: The player will not return to the last track played on the CD.

Press and hold the PROG button for 2 seconds to activate the last memory function on or off, The ON or OFF word will be displayed on the screen at this time. The last memory function is turned on by default.

SPEED ADJUSTMENT
Press SPEED- to slow down the playback speed by 5 times, and press
SPEED+ to speed up the playback speed by 5 times;

EQUALIZATION

Press the button to change the equalization. There are a total of 5 presets; BBS, POP, JAZZ, ROCK and CLASSIC.

A-B FUNCTION
When playing a track, press the A-B button once to mark start point A and press again to mark end point B. The track will now loop between these two points. Press the button again to cancel. NOTE: Point A and B must be within the same track.

CONNECTION TO OTHER SPEAKERS
Use the included 3.5 mm cable to connect the CD player to other devices such as external speakers, amplifiers, car’s audio system, etc.

OTHER FEATURES

KEY LOCK
Use the HOLD switch to lock all buttons (except volume control), to prevent any unwanted operation (for instance while doing sports or while storing it in your bag).

VOLUME ADJUSTMENT
The volume controller is located on the side of the player. Flick it to the left or right to decrease or increase the volume.
Remember to select an adequate volume level to prevent any harm.
Listening to loud music for long periods of time may cause permanent hearing damage.

TROUBLESHOOTING

Toggle the power switch to the ON position.
Buttons are locked.| Make sure the HOLD button on the side of the player is in the OFF position.
The CD player is out of battery.| Charge the CD player.
The player is damaged.| Contact us or ask a professional for repairs.
The CD cannot be read| The CD is installed incorrectly.| 1.Make sure you have removed the protective cardboard to reveal the lens.
2.Make sure the label side of the CD is facing upwards.
3.Ensure the CD is inserted correctly and fully into place.
The CD cannot be recognized.| Check the format. The player is only compatible with CD, CD-R, MP3 and HDCD
formats.
The CD is dirty or damaged.| 1.Make sure the CD is not heavily scratched or damaged.
2.Wipe the CD gently from the center towards the edge with a clean, soft cloth
3.Try another CD to check if the other one is faulty.
The lens is dirty.| Wipe the lens gently with a cotton swab.
NOTE: DO NOT TOUCH THE LENS WITH YOUR HANDS
The CD player isn’t charging| There is no current in the outlet.| Make sure the power outlet is working.
The charger is damaged.| Replace the charger with another one matching the specifications (DC 5V/1A).
The player is damaged.| Contact us or ask a professional for repairs.
Tracks skip while playing| The CD is scratched.| Use a dry cloth to clean the CD, or try another CD.
The player is subject to vibration or bumps (i.e. while in the car)| Keep the CD player stable while playing a CD.

WWW.KLIMTECHS.COM
Marcus Excelsior Limited 2512 Longhorn Place Office
Tower 8 Argyle Street, Mongkok, Kowloon Hong Kong
Authorised EU representative Marcus Excelsior Limited Bracken Rood No
51, Carlisle Offices 018 CV48 Dublin, Sandyford Dublin, Ireland
Authorised UK representative Marcus Excelsior LLP 71-75,
Shelton Street, Covent Garden, London, WC2H 9JQ, ENGLAND

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>