Micro-Mark 82088 Jig Scroll Saw Cross Saw Gourd Saw Instruction Manual

June 13, 2024
Micro-Mark

Micro-Mark 82088 Jig Scroll Saw Cross Saw Gourd Saw

Micro-Mark 82088 Jig Scroll Saw Cross Saw Gourd Saw

CRANKPIN REPLACEMENT INSTRUCTIONS

STEP 1
Use screwdriver to pry off the cover.

STEP 2
Rotate crankpin until shaft is pulled in as far as possible. If separated from link, push shaft in as far as possible.

STEP 3
Remove the collar from the shaft with a proper-fitting flat blade screwdriver or hex wrench as required.

STEP 4
Remove four screws holding crankcase.

STEP 5
Remove crankcase and rotate plastic link as shown so that shaft can be removed. Note: If link and shaft are already separated because pin fell out, remove link, shaft and pin.

STEP 6
Note replacement link has bearing which protrudes on side away from motor.

STEP 7
Install all parts in reverse order from disassembly.

STEP 8
Note that set screw on collar should be positioned at 90˚ from slot in shaft.

STEP 9

Final adjustment:
Run the saw and adjust the “tightness” of each of the four crankcase screws so that the saw runs freely (without loading down).

Customer Service

340 Snyder Avenue, Berkeley Heights, NJ 07922
Tech Support: Tech@micromark.com
www.micromark.com

Micro-Mark Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals