N600R WDS settings
- June 13, 2024
- TOTOLINK
Table of Contents
N600R WDS settings
It is suitable for: N600R
Application introduction:
Settings Solution about how to configure WDS to TOTOLINK products.
Diagram
Preparation
- Before configuration, make sure that both A Router and B Router are powered on.
- Connect your computer to the same network of router A and B.
- move the B router closer to the A router to find the B routing signals better for fast WDS.
- A Router and Router should be set to the same channel.
- Set both Router A and B should to the same band 2.4G.
- Choose the same models for A-router and B-router. If not, WDS function may not be implemented.
Set up steps
STEP-1:
Connect your computer to the router by cable or wireless, then login the router by entering http://192.168.0.1 into the address bar of your browser.
Note:The default access address varies depending on the actual situation. Please find it on the bottom label of the product.
STEP-2:
User Name and Password are required, by default both are admin in lowercase letter. Click LOGIN.
STEP-3: A-router setting
3-1. Firstly connect the Internet for A-router then please go to Wireless - >WDS Settings page, and check which you have selected.(The type of A-router and B-router should be same )
Select Enable , then Input MAC Address of B-router in A-router , then Click Add.
3-2. Please go to Wireless- >Basic Settings page, select Channel Number which you must choice equal for the B-router.
STEP-4: B-router setting
4-1. Secondly use Bridge Mode for B-router then please go to Wireless -> WDS Settings page, and check which you have selected.
Select Enable , then Input MAC Address of A-router in B-router and Select Auto for Data Rate , then Click Apply.
4-2. Please go to Wireless -> Basic Settings page, select Channel Number which you must choice equal for the A-router.
DOWNLOAD
N600R WDS settings – [Download PDF]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>