midmark 255 LED Light Cross Tube Assembly Instruction Manual
- June 13, 2024
- Midmark
Table of Contents
255 Light Cross Tube Installation
[002-10086-00]
255 LED Light Cross Tube Assembly
Warning
Always turn OFF light then disconnect power before removing covers.
Failure to do so may result in personal injury.
Disassemble Cross Tube from existing Light Fixture:
Remove Ballast from Cross Tube:
Re-assemble Cross Tube Assembly:
Final Step: Connect light to power source then verify operation…
A) Turn ON facility power breaker so there is power in customer supplied
wiring.
B) Turn light ON ) and adjust intensity as needed using light intensity
controls.
C) Position the light 36″ from the table and aim the light at the table.
D) Observe. There should be an evenly distributed circular pattern of bright
light, approximately 7.5″ inches in diameter, on the table surface.
E) Rotate the lighthead, lamp tube, cross tube, and down tube through their
range of motion. Release the lighthead at different positions.
F) Observe. The lighthead should be able to be positioned easily through the
entire range of its motion.
When the lighthead is released in any position, no drifting should occur at
any axis.
G) If any problems are discovered, refer to the troubleshooting guide for
adjustment and repair tips.
© 2018 Midmark Corp.
60 Vista Drive Versailles, OH 45380 USA “
1.800.643.6275 | 1.937.526.3662
midmark.com
TP200 20-42-FO-00012 Rev A1 C2169
003-10056-00
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>