How to Configure the AP Mode on the EX1200M
- June 13, 2024
- TOTOLINK
Table of Contents
How to Configure the AP Mode on the EX1200M?
It is suitable for: EX1200M
Application introduction:
To set up a Wi-Fi network from an existing wired (Ethernet) network so that multiple devices can share the Internet. Here takes EX1200M as demonstration.
Set up steps
STEP-1：Configure the extension
※ Please reset the extender first by pressing the reset button/hole on the extender.
※ Connect your computer to the extender wireless network.
Note:
1.The default Wi-Fi Name and Password are printed on the Wi-Fi Info Card to connect to theextender.
2.Do not connect the extender to the wired network until the AP mode is set.
STEP-2：Login to the management page
Open the browser, clear the address bar, enter 192.168.0.254 to the management page, Then check Setup Tool.
STEP-3：AP mode setting
AP mode supports both 2.4G and 5G. The following describes how to set up 2.4G first, then set 5G:
3-1. 2.4 GHz Extender Setup
Click ① Basic Setup ,-> ② 2.4GHz Extender Setup ->Select ③ AP mode , ④ setting the SSID ⑤ setting password , If you need to see the password,
⑥ check Show , Finally ⑦ click Apply.
After the setup is successful, the wireless will be interrupted and you need to reconnect to the Extender’s wireless SSID.
3-2. 5GHz Extender Setup
Click ① Basic Setup ,-> ② 5 GHz Extender Setup ->Select ③ AP mode , ④ setting the SSID ⑤ setting password , If you need to see the password,
⑥ check Show , Finally ⑦ click Apply.
STEP-4：
Connect the extender to the wired network through the network cable as shown below.
STEP-5：
Congratulations! Now all your Wi-Fi enabled devices can connect to the customized wireless network.
DOWNLOAD
How to Configure the AP Mode on the EX1200M – [Download PDF]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>