SAMSUNG MHC-015EE EHS HT Base Heater Kit Instruction Manual
- June 13, 2024
- Samsung
Table of Contents
**SAMSUNG MHC-015EE EHS HT Base Heater Kit Instruction Manual
**
Safety precautions
This installation manual explains how to install the Base heater kit used in Samsung EHS HT. Read this installation manual thoroughly before installing the Base heater kit for proper installation. (For installing product or other optional accessories, refer to corresponding installation manual.)
WARNING
Hazards or unsafe practices that may result in severe personal injury or death.
WARNING
- Consult qualified installer or service center for installation.
- Do not attempt to repair, disassemble, or modify the appliance yourself.
- There is potential risk of product damage, electric shock or fire. When repair is needed, consult qualified installer or service center.
- Contact qualified installer or service center when you need to remove or dispose the Base heater kit.
- Firmly fix and install the Base heater kit on the designated location with the installation accessories.
- If the Base heater kit is not firmly fixed, parts may fall apart and get damaged.
Preparing Base heater kit installation
Accessories
Base heater (1)| Fixing clips (4)| Fixing screws (4) (For fixing clips)|
Fixing screw (1) (For fixing PCB)| PCB & wire (1)| Installation manual (1)
---|---|---|---|---|---
| | | | |
CAUTION
- When installing the Base heater kit, you must use the designated accessories.
Disassembling the outdoor unit
Disassemble the outdoor unit in following order.
UB1-Outdoor
- Disassemble the top part of the outdoor unit.
- Disassemble the front cover on the right side of the outdoor unit.
- Disassemble the front cover on the left side of the outdoor unit.
- Disassemble the motor bracket.
- When the installation is complete, assemble the outdoor unit in reverse order.
Installing the Base heater kit
-
Install the Base heater on the bottom part of the outdoor unit and fix 4 places with the fixing clips and fixing screws.
-
To prevent the Base heater wire from interfering with the fan during operation, fix it to the motor bracket wire.
-
Fix the enclosed PBA on the control box as shown in the figure.
-
Use enclosed screw to fix 1 place on the PBA.
-
Connect the Base heater connector (white) as shown in the figure.
-
Connect the PBA connector (blue) as shown in the figure.
Connecting the PBA
Use enclosed wire to connect between Heater PBA terminal and Main PBA
terminal.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>