J M CORPORATION Slide In Shorty Style Helmet Headset Instruction Manual
- June 13, 2024
- J M CORPORATION
Table of Contents
Slide-in Shorty-Style
Helmet Headset
Installation Instructions
Slide In Shorty Style Helmet Headset
WARNING! Helmet speakers may not be legal in all jurisdictions. Check your local laws BEFORE using this product. J & M Corporation cannot control the circumstances surrounding the sale of this equipment, the quality of installation, or the specific helmet into which this equipment is installed. Accordingly, J & M Corporation makes no warranties, expressed or implied, related thereto. A helmet with this equipment installed may not protect the user from injury. The user assumes all liability in conjunction with accidents, injuries or losses of any kind arising out of the use of this product. Additionally, this product should not be used in any way that would impair the user’s ability to hear traffic or other noises. Accordingly, the volume should be kept low or off, depending upon the circumstances.
- Begin by inserting the small center tab on the headset into the back of your helmet between the interior and outer shell of your helmet. See Figure 1.
- Insert the large tab on the left side of the headset into your helmet in the same manner making sure that the headset is on the inside of the retention strap on your helmet. See Figure 2.
- Repeat this procedure for the right side.
- Reposition both sides of the headset as necessary so that both speakers are correctly positioned over your ears.
- After proper positioning of the speakers is accomplished, route both helmet straps through the small retention loops on both sides of the headset. See Figure 3.
- Pull the small, medium or large windsock (your preference) over the microphone.
- Use the correct Z-Series or P-Series lower section hook-up cord (sold separately) to connect this headset to your particular motorcycle audio system.
WARRANTY REGISTRATION FORM
Please fill out this card completely and mail it immediately after purchase.
Please be sure that your zip code and serial number (if applicable) are
legible. This will help us to serve you better.
(PLEASE PRINT)
Name __
Address
City _State ___ Zip _
Motorcycle ◯ Other ◯ E-mail ___
Make _ Model __
Year _
Product part number ___
Serial number (if applicable)____
Date of purchase _
Name of dealer it was purchased from _____
Mail to:
J&M Corporation
1415 S. Cherry Avenue
Tucson, AZ 85713
U.S.A.
WARRANTY AND REPAIR INFORMATION
TWO YEAR LIMITED WARRANTY In order to facilitate the servicing of this
warranty, the Warranty Registration Form should be filled out and returned
within 10 days of the date of purchase. However, return of the Warranty
Registration Form is not a precondition of this warranty, and this Warranty
will be observed by J&M CORPORATION whether or not the Warranty Registration
Form is returned, on the condition that other satisfactory evidence of the
date of the original purchase is provided to J&M CORPORATION.
WHO PROVIDES THE WARRANTY? This warranty is provided by J&M CORPORATION.
WHO IS PROTECTED? This warranty is extended only to the original owner of
this J&M CORPORATION product and may not be transferred or assigned.
WHAT IS COVERED AND HOW LONG? This warranty covers all defects in
material or workmanship of our product for a period of 2 years from date of
original retail purchase.
At its option, J&M CORPORATION will repair or replace any defective part(s) or
equipment.
The provisions of the warranty shall not apply to any unit which has been
subjected to misuse, neglect, incorrect mechanical or electrical installation,
unauthorized modifications, accident, nor to units which have been repaired or
altered outside of our factory.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY In the event that the
product does not conform to this warranty, the product should be shipped
prepaid to the J&M
CORPORATION service facility. Transportation charges, insurance fees, and
labor costs for shipment, removal, or reinstallation of our product are not
covered by this warranty. Loss or damage in shipment is the sole
responsibility of the freight carrier.
FOR YOUR INFORMATION Repair as provided under this warranty is the
exclusive remedy of the consumer. J&M CORPORATION shall not be liable for any
incidental or consequential damages or for breach of any express or implied
warranty on this product. Except to the extent prohibited by applicable law,
any implied warranty of merchantability or fitness for a particular purpose on
this product is limited in duration to the duration of the warranty. Some
states do not allow the exclusion or limitation of incidental or consequential
damages, or allow limitations on how long an implied warranty lasts, so the
above limitations or exclusion may not apply to you. This warranty gives you
specific legal rights which vary from state to state.
J &M CORPORATION reserves the right to make changes in design and to make
improvements in its products without the obligation to incorporate the changes
or improvements in any of its previously manufactured products.
J &M CORPORATION has not authorized anyone to make representations or
warranties other than the warranty contained herein.
The above warranty is effective for all products manufactured after 10/01/86.
NON-WARRANTY REPAIR RATES J &M CORPORATION reserves the right to change
the labor repair rates without prior notice. At the time of this printing the
out-of- warranty repair is $40 per hour for labor only. However, the customer
is advised to verify the current rate when he/she calls customer service to
obtain the return authorization number.
FACTORY SERVICE ADDRESS J&M Corporation, 1415 S. Cherry Avenue, Tucson,
Arizona, 85713, U.S.A. Tel:
1-800-358-0881
audio@jmcorp.com
www.jmcorp.com
CUSTOMER SERVICE NUMBER
1-800-358-0881
Thank you for the confidence you have shown in J & M by purchasing one of our innovative products. It will give you many hours of riding pleasure. If you have any questions during installation or require more information about this product, you may call our Customer service Department (English only, please) at 1-800-358-0881, Monday through Friday, 8:00 a.m. to 5:00 p.m. Mountain Standard Time, U.S.A.
J&M Corporation
Tucson, Arizona, U.S.A.
Tel. 1-800-358-0881
www.jmcorp.com
audio@jmcorp.com
Please complete
WARRANTY REGISTRATION FORM
on the reverse side and send to J&M Corporation
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>