MINELAB Z4C-0061 Wireless Headphone Instruction Manual
- June 13, 2024
- MINELAB
Table of Contents
MINELAB Z4C-0061 Wireless Headphone
ADVICE AND SAFETY INSTRUCTIONS
For complete product specification and operational guidance, read the
Instruction.
www.minelab.com/product-manuals
Manual at Alternatively, please contact us to make arrangements for a copy.
ASSEMBLY INSTRUCTIONS
For guidance on detector assembly, please refer to the Getting Started Guide included or visit:. www.minelab.com/product-manuals The Minelab website also provides information on accessories available for your detector.
WARRANTY TERMS
Please refer to www.minelab.com/support/product- warranty for full warranty terms and conditions. Register your product warranty online at register.minelab.com.
SAFETY CONSIDERATIONS
- Keep out of reach of children, small parts are a choking hazard.
- Do not mutilate the batteries.
- Dispose of batteries as per local regulations.
- Only charge the detector and accessories according to the instructions in the manual.
- Do not dispose of the detector or accessories in a fire.
- Disconnect coil before packing/storing as luggage.
- CAUTION — Risk of explosion if battery is replaced by an incorrect type.
- CAUTION — Only charge the battery in ambient temperatures between 0°C and 40°C.
- Headphone use at HIGH volume may cause reduced awareness of surroundings and could lead to hearing damage. Use at lower volumes advised.
- Adult supervision required when used by children.
REGULATORY INFORMATION
Federal Communications Commission (FCC) Statements (as applicable)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Part 15.105 NOTE : This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
US Responsible Party: MINELAB AMERICAS INC, 123 Ambassador Drive, Suite 123, Naperville, IL 60540, USA ComplianceManager@minelab.com.au
Compliance Statements for Canada (as applicable) This product meets the
applicable Innovation, Science and Economic Development Canada technical
specifications.
RSS-Gen notice: This device complies with Industry Canada’s license-exempt
RSSs.
Operation is subject to the following two conditions: 1) This device may not
cause interference; and 2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Modification
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
Simplified EU & UKCA Declaration of Conformity Hereby, Minelab Electronics Pty
Ltd declares that the radio equipment type [Refer to equipment listed in Table
1] complies with Directive 2014/53/ EU and The Radio Equipment Regulations
2017 (S.I. 2017/1206). Full text of the EU & UKCA declarations of conformity
are available at the following internet address:
www.minelab.com/compliance.
EU Importer: MINELAB ELECTRONICS PTY LTD, 2 Second Avenue, Mawson Lakes, SA
5095, Australia
License / Permit
The equipment operator is responsible for investigating and obtaining any required local license or permit for metal detecting activities.
WEEE
This symbol indicates that the equipment and its electrical accessories should
not be disposed of as household garbage.
These items should not be disposed of as unsorted municipal waste and should
be taken to a certified collection point for recycling and proper disposal.
Refer 2012/19/EU (Waste Electrical and Electronic Equipment).
Specification
Table 1
| |
---|---|---
| | |
VANQUISH
340/440/540| 5 to 143 kHz| <-30 dBm| 2.4to2.5GHz| O dBm
EQUINOX BOD/BOO| 3.7 to 143 kHz| <- 30 dBm| 2.4 to 2.5 GHz| – 5.9 dBm / – 0.5
dBm
EQUINOX 700/900| 2.5 to 143kHz| <- 30 dBm| 2.4 to 2.5 GHz| +6,3dBm
X-Terra Pro| 2.5 to 143 kHz| < -30 dBm| 2.4 to 2.5 GHz| +6.3 dBm
CTX 3030| 1.3 to 141kHz| <-30 dBm| 2.4to2.5GHz| 14dBm
GO-FIND Series| 7.4to8.2 kHz| <-30 dBm| 2.4to2.5GHz| B.9d8m
Excalibur II| 1.3 to 141 kHz| <- 30 dBm| –| –
Manticore| 2.5 to 143 kHz| <-30 dBm| 2.4 to2.5GHz| +6.3d8m
PRO-FIND Series
Gold Monster 1000| 11 to 13 kHz| <- 30 dBm| –| –
43 to 46.B kHz| <- 30 dBm| –| –
SDC 2300| 3.5 to146kHz| <- 30 dBm| –| –
GPZ 7000| 1.18 to 147kHz| <- 30 dBm| 2.4 to 2.5 GHz| O dBm
GPX 5000| 1.1to 145 kHz| <- 30 d8m| –| –
GPX 6000| 1.18 kHz to 147kHz| <- 30 d8m| 2.4 to 2.5 GHz| +B dBm
ML 80| –| –| 2.4- to 2.485 GHz| +5 d8 m
ML 100| –| –| 2.4 to 2.5 GHz| +3 d8m
ML 85| –| –| 2,4to2.5GHz| +O dBm
ML 105| –| –| 2.4 to 2.5 GHz| +3 dBm
Table 2
Detector| FCCIO| Anatel| Japan MIC| KC| ISEO|
NOM| BIS/ETA
---|---|---|---|---|---|---|---
VANQUISH 540| Z4C-0041| 17411-20-11695| 001-A16239| R-C-Taj-0041|
24927-0041| ANC2101C 00019753| ETA·S0-20210100676 R-4122011B
VANQUISH 340/440| 03956-21-11695| R-R-Tej-0041A| ICES-3( 8)/ NM8·3(8)
EQUINOX 800/800| Z4C-0022| 040 23-21-11695| 003-180034| R·CMM-Tej·
EOUINOXBOO
| 24927-0022| NYC-2202COE
20577
| ETA-S0·20210100634/63B R-41211974
EQUINOX **700/900*| Z4C-0054A| 21898-22-11695| 001·A19879| R·R-Tej-
0054A| 24927-0054A| NYC-2202COE 20577| ETA·S0·20221210452/465 R-41208482
X-Terra Pro| Z4C-0054| 21925·22·11695| 001·A19879| R·R·Tej-0054|
24927-0054| NYC·2202COE 20577| ETA·S0-20230301955 R-41208482
CTX3030| Z4C-1010| 1661B-20-11695| –| R·R-Tej-1010| –| ANC2301C
00004896| ETA·S0-20210100687 R-41236608
GO-FINO 44/88**| Z4C-2660| 17188-2011·695| 003 -18 0016| R·CMM-Tej· GO-
FIN□B6| 24927-2660| ANC2101C 00019753| ETA·S0-
2□21 0100638/ 840
GO-FINO 11/22| –| ICES-3(8 )/
NM8-3(8)
| –| –
Excalibur II| sOoC| 0413 9 -21-11695| –| R·R·Tej-0454| –|
NTC22.0434| –
**Manticore*| Z4C·0049| 21899-22-11695| 001·A19880| R·R·Tej-0049|
24927-0049| NYC·2202COE 20577| ETA·S0-20221210303 R-41206482
PRO-F I NO**
Series
| s□oc| 00108-21-11695| –| R·R·T j-0018| ICES-3( 8)/ NMB-3(8)| ANC2101C
00019754| –
Gold Monster 1000| sOoC| 06876 -18-11895| –| R·R·T j-0019| ICES-3(
8)/ NMB-3(8)| ANC2301C 00004897| R-41206482
soc 2300| s□oc| 05531 -20·1 1B95| –| R·R·T j-0012| –| ANC2301C
00004897| R-41206482
GPZ7000| Z4C-7000| 0598 5-18·11695| –| –| –| ANC2301C 00004896| ETA·S□-2
0230 201248
R-41248320
GPX5000| sOoC| 04 112· 21-11695| –| –| –| –| –
GPX8000| Z4C-0039A| 03121-21-11695| –| R·R·Tej-0039| 24927-0039|
ANC2301C 00004897| ETA·S0-20230201251 R-41206482
M L SO| 2APN8· ML80| –| 204·
800553
| R-R-Tej-ML80A| 24927·ML80A| IFT: RCPMI
3021-0175
| ETA·S0-20230201251
R-41216798
M L 100| Z4C·ML100A| –| 210-201818| R-R-Tej- ML100A| 24927-MLlOOA| IFT: RCPMI
3021-0175-Al
| ETS·S0·20221210937
ML85| Z4C-ML85| 02940-23-11695| 21□·18890B| R-R-Tej·ML85| 24927-ML85|
IFT:MIML23· 01007| ETA-S0-20221210297
R-41216798
ML 105| Z4C·ML105| 21929-22·11695| 210-201902| R-R-Tej-ML105| 24927·ML105| IFT:MIML23·
01007
| ETA·S0·20221210923
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries. | The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any Minelab Electronics, PO Box 35, Salisbury South, South Australia 5106 use of such marks by [Minelab Electronics Pty Ltd] is under license. Other trademarks and trade names are those of their respective owners.
Bluetooth
Certification and logo usage dependant on product and region
References
- MINELAB - Register Your Minelab
- Concidiones de garantía limitadas del producto Detectores de metales de alto rendimiento
- StackPath
- StackPath
- StackPath
- StackPath
- StackPath
- Product Warranty | Minelab Metal Detectors
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>