How to setup repeater mode on A1004
- June 13, 2024
- TOTOLINK
Table of Contents
How to setup repeater mode on A1004?
It is suitable for: A1004、A3
Application introduction:
Repeater mode expands the upper-level wireless signal by wireless to extend the wireless signal to a farther distance. Here is an example of A1004.
Diagram
Set up steps
STEP-1：Assigned manually IP address
A1004 LAN IP address is 192.168.0.1, please type in IP address 192.168.0.x （“x” range from 2 to 254）, the Subnet Mask is 255.255.255.0 and Gateway is 192.168.0.1.
STEP-2：Login to the management page
Open the browser,clear the address bar,enter 192.168.0.1 to the management page，click Advance setup.
The repeater mode supports both 2.4G and 5G. Here’s how to set up 2.4G first, then set 5G.
STEP-3：2.4G repeater settings
3-1. 2.4GHz wireless setting
❶ Click Wireless Setup -> ❷Select 2.4GH Basic network -> ❸ Set Wireless SSID -> ❹ Set Wireless Password -> ❺ Click Apply.
3-2. 2.4 GHz extension setting
❶ Click Wireless Multibridge -> ❷ Select 2.4GHz -> ❸ Select Repeater -> ❹ Click AP Scan -> ❺ Select the wireless you need to expand -> ❻ Enter the upper-level wireless password, and finally ❼ click Apply.
STEP-4：5G repeater settings
4-1. 5GHz wireless setting
❶ Click Wireless Setup -> ❷ Select 5GH Basic network -> ❸ Set Wireless SSID -> ❹ Set Wireless Password -> ❺ Click Apply.
4-2. 5GHz extension setting
❶ Click Wireless Multibridge -> ❷ Select 5GHz -> ❸ Select Repeater -> ❹ Click AP Scan -> ❺ Select the wireless you need to expand -> ❻Enter the upper-level wireless password, and finally ❼ click Apply.
STEP-5：
After the setting is successful, please obtain the IP setting automatically, and the computer can connect to the network.
STEP-6：
Now all Wi-Fi enabled devices can connect to a custom wireless network.
FAQ Common problem
Q1: After the bridge mode is set successfully, you will not be able to access the router. If you need to revisit, there are two ways!
1. Press the reset button/hole on the router to restore the router to factory settings;
2. Log in to the router management page by setting a fixed IP (refer to STEP-1).
DOWNLOAD
How to setup repeater mode on A1004 – [Download PDF]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>