POLAR CT423 U-Series Double Door Pizza Counter Instruction Manual

POLAR CT423 U-Series Double Door Pizza Counter Instruction Manual

Safety Instructions

• Position on a flat, stable
• A service agent/qualified technician should carry out installation and any repairs if Do not remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• DO NOT use jet/pressure washers to clean the
• DO NOT use the appliance
• DO NOT use this appliance to store medical
• DO NOT stand or support yourself on the base, drawers or
• DO NOT allow oil or fat to come into contact with the plastic components or door Clean immediately if contact occurs.
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the
• Always switch off and disconnect the power supply to the unit before
• Keep all packaging away from Dispose of the packaging in accordance with the regulations of local authorities.
• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their
• POLAR recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional
• POLAR recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Caution Risk of Fire

• Do not store explosive substances such as aerosol cans with a flammable propellant in this
• Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the
• Warning: Do not damage the refrigerant
• Warning: Do not use electrical appliances inside the food storage compartments of the

Product Description

CT423 – Pizza counter with Granite top, 2 doors and dough drawers
CT424 – Pizza counter with Granite top, 2 doors

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:

• POLAR Refrigerator
• Instruction manual

POLAR prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately

Installation

Note: Not for use in vans or trailers, food trucks or similar vehicles.
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand

1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all
2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 20cm clearance on the top. NEVER LOCATE NEXT TO A HEAT
3. Set the brakes on the castors to keep the appliance in position.

Attach Refrigerated Counter Top (G611 onto CT423, G609 onto CT424) (This

is optional)

1. Remove the appliance from the
2. Tip the appliance back and loosely attach the three brackets to the underside of the counter top, using suitable Do not fully tighten at this stage.
3. Lower the Counter Top unit onto the marble Ensure the side brackets are postponed on the inside of the marble rim.
4. Push the side brackets flush with the marble and tighten the bracket

Fit Glass Panels G611/G609

2. Screw the collars to the rim of the
3. Slot the two side panels into the collars, with the holes in the glass at th
4. Screw a grub screw into each collar to secure the

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:

• Only store foodstuffs in the appliance when it has reached the correct operating
• Do not place uncovered hot food or liquids (like acidic fluids) inside the appliance (as it candamage the evaporator).
• Wrap or cover food where
• Do not obstruct the fans inside the
• Avoid opening the doors for prolonged periods of

4. Slot the rear panel into the collars, with the holes in the glass at the
5. Screw a grub screw into each collar to secure the
6. Slot the plastic plugs into each of the
7. Screw the brackets to the inside of each panel using the bolt
8. Place the top panel onto the brackets, ensuring all holes line up.Insert the plugs and attach the top panel to the brackets with the bolt assembly

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:

• Only store foodstuffs in the appliance when it has reached the correct operating
• Do not place uncovered hot food or liquids (like acidic fluids) inside the appliance (as it candamage the evaporator).
• Wrap or cover food where
• Do not obstruct the fans inside the
• Avoid opening the doors for prolonged periods of

Turn On

1. Ensure the power switch is set to [ O ] and turn on at the
2. Switch on the Power [ I ]. The current temperature within the appliance is

Control Panel

Set the Operating Temperature

1. Hold the SET button for 3 The value of the current set point will be displayed.
2. Press the or  buttons to display the required
3. Press the SET button to store the

Manual Defrost

• The appliance will automatically run a defrost cycle every six
• To manually defrost the appliance: Press and hold the defrost button “ aux ” for 2 seconds to begin a manual The defrost light illuminates.

The defrost cycle will end automatically

Cleaning, Care & Maintenance

• Clean the interior of the appliance as often as
• Do not use abrasive cleaning These can leave harmful residues.
• Clean the door seal with warm soapy
• Always wipe dry after
• Do not allow water used in cleaning to run through the drain hole into the evaporation
• Take care when cleaning the rear of the Sharp edges can cut.

Refrigerating tips:

• Condensation and ice will form with frequent and prolonged opening of the
• Operating outside of the recommend temperature range and placing next to a heat source will also increase the amount of ice and internal/external If external condensation occurs wipe the surface down with a cloth.
• Excessive ice will result in longer running times that will increase energy consumption and increase the deterioration of components.
• If the gasket or seal is damaged or deformed, energy consumption will To restore efficiency, replace gasket.

Stainless Steel Care

To maintain the stainless steel exterior of your Polar item, please consider the following information:

Never:

• Use abrasive Scourers or scrubbing pads,
• Use Chlorinated or acidic detergents
• Allow anything g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary, clean them off right away.
• Allow the surface to remain

Do:

• Clean often.
• Use soft Cloths or plastic
• Rub with the grain of the metal, rather than across
• Use detergents and polish designed for cleaning Stainless
• Ensure that the cleaning products are washed off fully and that the steel is left

Cleaning the Condenser

• The condenser is part of the refrigeration The condenser requires monthly cleaning.
• Always disconnect power supply before carrying out Routine Maintenance.
• Failure to clean the condenser will reduce the __  performance and life of your Polar unit and mayinvalidate your warranty.
• These models have a removable filter which can be cleaned with a vacuum

Troubleshooting

A qualified technician must carry out repairs if required.

plugged in correctly and switched on
Plug or lead is damaged| Replace plug or lead
Fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check mains power supply
The appliance turns on, but the temperature is too high/low| Too much ice on the evaporator| Defrost the appliance
Condenser blocked with dust| Clean the Condenser
Doors are not shut properly| Check doors are shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the refrigerator to a more suitable location
Ambient temperature is too high| Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance| Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly levelled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to the drain is obstructed| Clear the floor of the appliance (if applicable)
The water container is damaged| Consult a qualified Technician
The drip tray is overflowing| Empty the drip tray (if applicable)
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change if necessary

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may be subject to change without notice.

Model

|

Voltage

|

Power

|

Current

| Temperature Range| Net usable Capacity (Ltr)|

Refrigerant

| Dimensions H x W x D mm| Weight (kg)
---|---|---|---|---|---|---|---|---
CT423| 220-240V~

50Hz

| 300W| 1.8A| 2°C ~ 8°C| 266| R600A 95g| 1000 x 2025 x 800| 362
CT424| 300W| 1.8A| 2°C ~ 8°C| 266| R600A 95g| 1000 x 1510 x 800| 257

Note: For optimal product performance and efficiency, please ensure to mind the net usable capacity (load limit) when filling.

Electrical Wiring

POLAR appliances are supplied with a 3 pin BS1363 plug and lead. The plug is to be connected to a suitable mains socket.
POLAR appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E This appliance must be earthed.

If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Disposal

EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Alternatively call the POLAR helpline for details of national disposal companies within the EU.

compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose ofthis product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
POLAR products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.
Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.

Read More About This Manual & Download PDF:

References

• Polar Refrigeration - Commercial Refrigeration

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>