INTELLINET 507349 Gigabit Ethernet Media Converter Instructions
- June 13, 2024
- INTELLINET
Table of Contents
Gigabit Ethernet Media
Converter Instructions
Models 506533 (IMC-MMSCG), 507349 (IMC-SMSCG20KM)
Important: Read before use.
507349 Gigabit Ethernet Media Converter
For additional benefits:
Scan to register your product warranty
or go to:
|
---|---
register.intellinet-network.com/r/506533| register.intellinet-
network.com/r/507349
Instructions
For specifications, visit intellinet-network.com. To register your product warranty, go to the weblink or scan the
QR code for your model, which you can find on the cover of this manual.
Models
- 506533: 1000Base-T to 1000Base-SX (SC) Multi-Mode, Wavelength 850 nm, 550 m (1800 ft.)
- 507349: 10/100/1000Base-T to 1000Base-LX (SC) SingleMode, Wavelength 1310 nm, 20 km (12.4 mi)
Connections
Twisted Pair – RJ45
Connect the UTP port of the media converter to an RJ45 port on the network
(e.g., to an Ethernet switch). Cat5e or better cabling is recommended.
Fiber Optic
As shown above, two fiber optic cables need to be connected between two
ideally identical media converters. Make a connection from Media Converter 1
TX to Media Converter 2 RX, and from Media Converter 1 RX to Media Converter 2
TX. Maximum length and fiber cable specification depend on the model. (See
Models.)
Front panel
| LED | Description |
|---|---|
| PWR | The power adapter is connected when lit. |
| 1000M | 1000 Mbps link on the twisted pair connection when lit. |
| 100M | 100 Mbps link on the twisted pair connection when lit. |
| LINK/ACT (TP = RJ45; FX = FIBER) | – Active link when lit; |
– Data traffic when flashing;
– No active network link when unlit.
FDX/COL (FOR TP/RJ45)| – Full duplex connection when lit;
– Data collisions when flashing;
– Half duplex when unlit.
SD (FOR FX/FIBER)| – Fiber optic signal is detected when lit;
– No signal when unlit.
Rear Panel
Power
Plug the power adapter into the 5 V DC input jack on the media converter, then
connect it to a regular power outlet. Only use the included power adapter or
one with matching specifications (output of 5 V DC, at least 1 A).
WASTE ELECTRICAL & ELECTRONIC EQUIPMENT DISPOSAL OF ELECTRIC AND ELECTRONIC
EQUIPMENT
(Applicable In The European Union And Other Europen Countries With Separate
Collection Systems)
** This symbol on the product or its packaging means that this product must
not be treated as unsorted household waste. In accordance with EU Directive
2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), this
electrical product must be disposed of in accordance with the user’s local
regulations for electrical or electronic waste. Please dispose of this product
by returning it to your local point of sale or recycling pickup point in your
municipality.
WARRANTY
**intellinet-network.com
REGULATORY STATEMENTS
FCC Class B
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of Federal Communications Commission
(FCC) Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions may cause harmful interference to
radio communications. However, there is no guarantee that nterference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or televisionreception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: reorient or relocate
the receiving antenna; increase the separation between the equipment and the
receiver; connect the equipment to an outlet on a circuit different from the
receiver; or consult the dealer or an experienced radio/TV technician for
help.
CE/UKCA
This device complies with the requirements of CE 2014/30/EU (UKCA
Electromagnetic Compatibility Regulations 2016) and / or 2014/35/EU (UKCA
Electrical Equipment [Safety] Regulations 2016). The Declaration of Conformity
for is available at:
support.intellinet-network.com/barcode/506533
support.intellinet-network.com/barcode/507349
North America
IC Intracom America
550 Commerce Blvd.
Oldsmar, FL 34677, USA| Asia & Africa
IC Intracom Asia
4-F, No. 77, Sec. 1, Xintai 5th Rd.
Xizhi Dist., New Taipei City 221, Taiwan| Europe
IC Intracom Europe
Löhbacher Str. 7, D-58553
Halver, Germany
---|---|---
All trademarks and trade names are the property of their respective owners.
intellinet-network.com
All trademarks and trade names are the property of their respective owners. ©
IC Intracom. All rights reserved.
Intellinet Network Solutions is a trademark of IC Intracom, registered in the
U.S. and other countries.
Printed on recycled paper.
INT_506533_7349_QIG_0823_REV_5.11
References
- Intellinet Network Solutions - Provider of PoE and Data Center Product
- Intellinet Network Solutions Account and Product Registration
- Intellinet Network Solutions Account and Product Registration
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>