HAMPTON BAY 93008 Cornhole LED Ring Light User Guide
- June 13, 2024
- HAMPTON BAY
Table of Contents
Use and Care Guide
Cornhole LED Ring Light
Item #1009 284 201
Model #93008
PACKAGE CONTENTS
PLANNING FOR A SUCCESSFUL ASSEMBLY
□ Read all instructions before assembly and installation.
□ Inspect each part for defects that may have occurred during shipping. If any
parts appear missing or damaged, do not assemble product.
Contact Hampton Bay customer service.
□ Do not use this product for other than its intended purpose.
□ Keep your receipt and these instructions for proof of purchase.
Installation and Use
-
Preparing for installation
□ Attach the LED ring light (A) to the back of the cornhole board using the four (4) screws (E) provided.
□ Peel off the sticker located on the battery compartment (B), and attach to the back of the board.
-
First time use
□ Switch battery compartment (B) to the “ON” position.
□ Remove the pull-tab at the end of the remote control (D).
□ Select the desired color on the remote control (D).
Maintenance
Replacing the battery
CAUTION: When replacing the batteries, use two (2) LR6 AA 1.5V alkaline
batteries.
IMPORTANT: Dispose of the batteries in accordance with local, state, and
federal regulations.
NOTE: For best performance, replace with a LR6 AA 1.5V alkaline battery
when performance diminishes.
□ Remove and save the screw at the top of the battery compartment (B).
□ Slide off the battery cover.
□ Replace the old batteries with two (2) new LR6 AA 1.5V alkaline batteries.
□ Slide the battery cover back on to the battery compartment (B) and secure
using the screw that was removed in the first step.
Battery Instructions
□ Adult supervision is necessary when changing or disposing of batteries.
□ Make sure the unit is switched to the “OFF” position when changing
batteries.
□ Batteries must be inserted with the correct polarity.
□ Do not mix old and new batteries or batteries of different types such as
alkaline, standard (carbon-zinc) and re-chargeable (nickel cadmium or nickel
metal hydride) batteries.
□ The supply terminals are not to be short-circuited under any circumstances.
□ Exhausted batteries are to be removed from the unit.
□ Replace batteries when the light is faint. Replace all batteries at the same
time.
□ Only batteries of the same or equivalent type as recommended are to be used.
□ Do not allow any parts of the unit to come in contact with heat or flame.
□ Never throw batteries in a fire or attempt to open outer casing. Batteries
may explode or leak.
□ Dispose of old batteries carefully. Batteries should be recycled or disposed
of as per manufacturer’s recommendations.
□ Batteries are harmful if swallowed, so keep away from young children.
□ Remove batteries when not used for an extended period, or when depleted.
Batteries can corrode over time and may cause permanent damage to the unit.
□ Discharged batteries should be removed immediately from the battery
compartment in order to avoid leakage.
Troubleshooting
| Problem | Solution |
|---|---|
| LED light is not lighting up. | □ The battery is not making contact. Make sure |
batteries are properly placed inside of the battery compartment.
□ The battery is reaching the end of its useful life. Replace the old battery
with a new battery.
Warranty
The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only to the original consumer and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specifically disclaims any warranty, whether expressed or implied, or fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HamptonBay.com.
HAMPTONBAY.COM
Llama al 1-855-HD-HAMPTON para asistencia adicional.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>