Bushnell BB1050W Lightweight Binoculars Owner’s Manual
- June 13, 2024
- Bushnell
Table of Contents
Bushnell BB1050W Lightweight Binoculars
Product Information
This product is a binocular with the following models: BB842W, BB1042W, BB1050W, BB1250W. It is manufactured by Bushnell and is part of the Legend series. The binocular features a center focus knob, twist-up eyecups, a diopter adjustment ring, and objective lens covers. It also has a tripod adapter socket for mounting on a tripod. The binocular is designed to provide a comfortable view of the full image and exclude extraneous light. It is important to note that looking directly at the sun with this binocular can cause serious damage to your eyes, so it should be avoided at all times.
Product Usage Instructions
- Eyecup Adjustment:
- For use without eyeglasses or sunglasses, twist up the eyecups to place your eyes farther from the binocular’s ocular lenses.
- This will provide the correct eye relief distance and allow you to see the full field of view.
- IPD (Interpupillary Distance) Adjustment:
- Point the binoculars at a white wall or blank area of the sky.
- Hold the binoculars and view through them as you normally would.
- Grasp each side of the binocular firmly and move the left and right sides closer together or farther apart until you see a single image with no shaded areas.
- Focus and Diopter Adjustment:
- Adjust the eyecups and IPD as described in the previous sections.
- Cover the objective lens on the right side of the binocular using the attached lens cap or your hand.
- Using the center focus knob, focus on a distant object with fine detail until it appears as sharp as possible when viewed through the left side of the binocular.
- Uncover the objective lens on the right side and cover the left objective lens while continuing to view the same object.
- Rotate the diopter adjustment ring located directly below the right eyecup (not the center focus knob) to bring the object into focus in the right side of the binocular.
- Avoid over-turning or forcing the diopter mechanism.
- If you are unable to bring the object into focus for your right eye by adjusting the diopter ring, make sure the left side is still in focus and repeat the steps.
- The diopter adjustment provides fine focus on one side of the binocular (right only) to accommodate slight differences in the vision of your left and right eyes.
- Neckstrap Attachment:
- Attach the neckstrap to the strap lug of the binocular for convenient carrying.
- Tripod Mounting:
- The binocular has a tripod adapter socket for mounting on a tripod for stabilized viewing.
Always refer to the provided user manual for detailed instructions and safety guidelines.
PARTS GUIDE
- Ocular Lens A
- Center Focus Knob B
- Twist-Up Eyecups C
- Tripod Adapter Socket* D
- Objective Lens E
- Diopter Adjustment Ring F
- Objective Lens Covers G
under cap
Thank you for purchasing your new Bushnell® Legend® binoculars.
This manual will help you optimize your viewing experience by explaining how
you can adjust the binocular to your eyes, and how to care for this
instrument. Read the instructions carefully before using your binocular.
NEVER LOOK DIRECTLY AT THE SUN WITH YOUR BINOCULAR, AS IT MAY CAUSE SERIOUS
DAMAGE TO YOUR EYES
EYECUP ADJUSTMENT
Your Bushnell Legend binocular is fitted with eyecups (Fig. 1, next page) that
provide a comfortable view of the full image and help to exclude extraneous
light. For use without eyeglasses or sunglasses, twist up the eyecups (Fig. 2,
next page). This will place your eyes farther from the binocular’s ocular
lenses, at the correct eye relief distance, allowing you to see the full field
of view.
IPD (INTERPUPILLARY DISTANCE) ADJUSTMENT
The spacing between the pupils of your eyes, called “interpupillary distance,”
varies from person to person. To match your binoculars to your IPD or “eye to
eye” width:
- Point them at a white wall or blank area of the sky. Hold the binoculars and view through them as you normally would. Don’t worry about focus yet.
- Grasp each side of the binocular firmly. Move the left and right sides closer together or farther apart (Fig. 3, next page) until you see a single image with no shaded areas.
FOCUS AND DIOPTER ADJUSTMENT
- First, adjust the eyecups and IPD as described in the previous sections.
- Using the attached lens cap or your hand, cover the objective lens on the right side of the binocular.
- Using the center focus knob, focus on a distant object with fine detail (e.g., brick wall, tree branches, etc) until it appears as sharp as possible when viewed through the left side of the binocular.
- Uncover the objective lens on the right side, and cover the left objective lens while continuing to view the same object.
- Rotate the diopter adjustment ring located directly below the right eyecup (Fig. 4), NOT the center focus knob to bring the object into focus in the right side of the binocular. Avoid over-turning or forcing the diopter mechanism. If you are unable to bring the object into focus for your right eye by adjusting the diopter ring, make sure the left side is still in focus (repeat steps #2-4 if necessary). The diopter adjustment essentially provides “fine focus” on one side of the binocular (right only) to allow for slight differences in the vision of your left and right eyes.
- Your binocular should now be adjusted for your eyes. Focusing for any distance can now be done simply by turning the center focus knob. Make a note of your diopter setting (position of plus and minus marks on diopter ring relative to index mark on binocular below the ring) for future reference in case the ring is moved accidentally or by another person using your binocular.
NECKSTRAP ATTACHMENT
To attach the neckstrap, thread the ends of the neckstrap through the strap lug (Fig. 5) on each side of the binocular, then back through the plastic buckle on the strap (Fig. 6). Adjust the position of the binoculars on your chest as they hang around your neck to your preference, by changing the length of the strap section which passes through the strap channel and buckle by an equal amount on each side. Tug on the binocular to make sure it is securely fastened to the strap before letting go of it. If you prefer to use an aftermarket strap that has metal O-rings, attach them to a plastic zip tie placed on the strap lugs rather than installing them directly on the lug, to avoid damaging the finish on the binocular via contact with the rings.
TRIPOD MOUNTING
To attach the binocular to a tripod or monopod, unscrew or pull off the cap which covers the threaded socket at the far end of the center hinge (Fig. 7), and set it aside in a safe place. Use a compatible binocular tripod adapter accessory (90o angle bracket), such as the Bushnell #161002CM, to attach your Legend binocular to any standard tripod in a horizontal position to provide a stable image during prolonged viewing.
WATERPROOF / FOGPROOF
Getting caught in a heavy downpour of rain, or accidentally splashing your Legend binocular during a boating excursion won’t be a problem. The binocular is manufactured and tested to withstand water exposure up to IPX7 standards. Fogproof protection is achieved from dry Nitrogen purging that removes all internal air, which can retain moisture.
CARE OF THE OPTICS
- Your Bushnell Legend binocular will provide years of trouble-free service if it receives the normal care you would give any fine optical instrument.
- Avoid sharp impacts. Set the binocular down gently on hard surfaces.
- Tug on the strap after attaching, making sure it is securely fastened to the binocular before placing it around your neck.
- Store your binocular in a cool, dry place whenever possible.
CLEANING
- First, blow or brush away any dust or debris on the lens (using “canned air” or a soft lens brush).
- To remove dirt or finger prints, clean with the supplied soft storage bag (made of washable micro-fiber cloth), rubbing in a circular motion. Use of a coarse cloth (including paper towels) or unnecessary rubbing may scratch the lens surface and eventually cause permanent damage. The included storage bag/micro-fiber cloth is ideal for the routine cleaning of your optics. Simply breathe lightly on the lens to provide a slight amount of moisture, then gently rub the lens with the micro-fiber cloth.
- For a more thorough cleaning, photographic lens tissue and photographic lens cleaning fluid or isopropyl alcohol may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
- To prevent potential damage to the optical coatings on the binocular’s lens surfaces, never use household window cleaning liquids. Avoid using facial tissue or clothing that may have fibers which can be abrasive and hold oils or dirt.
Technical Specifications
SKU
| Magnification| ****
Objective Diameter
| Prism System| Field of view ft@1000yds / m@1000m| Exit Pupil (mm)| Eye Relief (mm)| ****
Close Focus (ft/m)
| ****
Length (in/mm)
| ****
Weight (oz /g)
---|---|---|---|---|---|---|---|---|---
BB842W| 8x| 42 MM| Roof| 315 /105| 5.25| 18| 15 / 4.6| 5.6/142| 20 / 567
BB1042W| 10x| 42 MM| Roof| 273 / 91| 4.2| 15.4| 17 /5.2| 5.4/137| 20 / 567
BB1050W| 10x| 50 MM| Roof| 273 / 91| 4.8| 16.5| 17 /5.2| 7.2/183| 29.6 / 839
BB1250W| 12x| 50 MM| Roof| 234 / 78| 4.1| 14.8| 20 / 6.1| 7.2/183| 29.6 / 840
Products manufactured on or after April 2017 are covered by the Bushnell
Ironclad Warranty. The Ironclad Warranty is a full lifetime warranty that
covers the lifetime of this Product. Each Product has a defined lifetime;
lifetimes can range from 1 to 30 years. This Product’s lifetime can be found
at the website listed below and/or on the Bushnell webpage specific to this
Product.
We warrant that this Product is free from defects in materials and workmanship
and will meet all represented performance standards for the lifetime of this
Product. If this Product isn’t working properly due to a covered defect, we
will, at our option, either repair or replace it and ship it back to you at no
charge. This warranty is fully transferable and does not require a receipt,
warranty card, or product registration. This warranty does not cover the
following: electronic components; batteries; cosmetic damage; damage caused by
failing to properly maintain the product; loss; theft; damage as a result of
unauthorized repair, modification, or disassembly; intentional damage, misuse,
or abuse; and ordinary wear and tear. This Warranty will be void if the date
stamp or other serialization codes have been removed from the Product.
To view the full warranty and find details on how to request service under the
warranty, go to our website at
www.bushnell.com/warranty. Alternatively,
you can request a copy of the warranty by calling us at
1-800-423-3537 or writing to us at one
of the following addresses:
IN U.S.A. Send To:
Bushnell Holdings, Inc. At Rtn.: epairs
9200 Cody
Overland Park, Kansas 66214
IN CANADA Send To:
Bushnell Holdings, Inc. At Rtn.: epairs
140 Great Gulf Drive, Unit B Vaughan, Ontario L4K 5W1
For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information.
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2020 Bushnell Outdoor Products
©2020 Bushnell Outdoor Products
Bushnell,™, ®, denote trademarks of Bushnell Outdoor Products
www.bushnell.com
9200 Cody, Overland Park, KS 66214
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>