STARK ST-36 Wireless SOS Button Instruction Manual
- June 13, 2024
- STARK
Table of Contents
STARK
OPERATING
MANUAL
Wireless SOS Button ST-36
- Please read the installation instructions before installin and using the product.
- Please keep this instruction manual for easy reference in the future.
CONTENTS
The wireless SOS button with low power consumption and high stability. Ultra- low power consumption design, with a long service life, on-site alarm prompt sound,battery low power prompt function, battery low power report to alarm host function. This product is suitable for all kinds of old-age care institutions, hospitals and families. When the elderly feel unwell or other emergency, you can pull the emergency rope or press the emergency button.
Technical Specifications
- Working voltage: DC 3V(2pcs 1.SV/AA)
- Standby current: sSuA
- Alarming current: sSOmA
- Wireless frequency: 433.92MHz
- Wireless range: >300meter{open area)
- Working Temperature: -10° C-+50° C
- Working humidity: !5:80% (no condensation)
SCHEMATIC DIAGRAM OF FRONT COVER
SCHEMATIC
DIAGRAM OF BOTTOM BOX
Feature
- Micro power consumption design
- Double use of SOS pull and SOS button
- Battery low power prompt
- Battery low power report to alarm host
- The scene sound and ligh tprompt when alarm
- Automatic detection of newand old battery loading prom ptfunction
Instructions
Power ON
When the battery is po wered on, the emergency button will check whether the
battery is old or new. When the battery voltage is lo wer than 2.4V, it is an
old batt ery, and the green tight 1 time flashed . When the installed battery
voltage is more t han 2. 4 V , it is a new battery, there d light 1 time
flashed, and also with send “battery restore” report to alarm host.
Battery Detection
To ensure that wireless products can work normally, if the emergency button
flashes green light 1 times in each 50 seconds (accompanied with 1 sound of
“Di”) or when the low power report reminds the host means the battery voltage
is insufficient, please replace the battery timely.
Alarming
Alarm will be triggered when the emergency rope is pulled orthe emergency
button is pressed. At this time, the red light will flash quickly and the
buzzer will give an alarm for 15 seconds. If the user wants to turn off the
alarm quickly, pull the emergency cord or
press the emergency button again.
Installation
- Open the cover of the emergency button, remove the battery insulation, will auto enter the working state immediately.
- Install the emergency button into thei ispec fied postion by double-sided tape or screws.
Installation Method 1
Installation Method 2
- 3M paster affixed to the back of the installation box.
- Wipe clean where installation is needed, and affix the installation box.
Note: In order to ensure the reliable operation of the system.
users need to test the system regularly.
If any problem Is found during the test, please consult relevant personnel
Immediately to solve it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>