RALPH LAUREN RL 2026 Geneva Medium Sconce Installation Guide
- June 4, 2024
- ralph lauren
Table of Contents
RALPH LAUREN RL 2026 Geneva Medium Sconce
Item # RL 2026
ASSEMBLY INSTRUCTIONS
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips
- Screwdriver
- Slotted Screwdriver
- Drill
- Hammer
- Pencil
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove frame (F) from fixture base (B) by removing screws (E).
-
Remove mounting plate (K) from fixture (B) by removing threaded caps (I).
-
Install mounting plate (K) to junction box and secure with mounting screws (D).
-
Using fixture (B) as a guide, line up with the junction box and mark anchor positions.
-
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (J).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (J).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (J).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (B) to mounting plate (K) and secure with threaded caps (I), then secure wood screws (C) to anchors (A).
-
Install glass panels (G) to frame (F) and secure by bending metal tabs (H).
-
Install light bulbs into the sockets.
-
Install frame (F) to fixture (B) and secure with screws (E).
Care Instructions
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>