RALPH LAUREN RL2733WVGCG Carrington Medium Sconce Instruction Manual
- June 3, 2024
- ralph lauren
Table of Contents
RALPH LAUREN RL2733WVGCG Carrington Medium Sconce
ASSEMBLY INSTRUCTIONS
To assemble safety cables:
- Join fixture safety cables with safety cable from wal.
- Wrap both safety cable around the cable lock nut.
- Secure by tlghtenlng both hex nuts untl tght.
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove back plate (B) from base of light fixture (E) by removing base screws (F) in counter-clockwise direction.
-
Insert light bulbs into sockets.
-
Position back plate (B) horizontally on the wall outlet box. Mark center points for mounting slot with a pencil on the wall. Remove back plate (B).
-
Drill small holes on each point location on the wall, each hole should be large enough to accommodate to the plastic anchor (A). Push plastic anchors (A) into the holes in the wall.
-
Affix back plate (B) to wall oultet box, aligning holes and secure by inserting mounting screws (D) to the holes of outlet box and screws (C) to the plastic anchors (A) in the wall.
-
Gently pull the wires from the wall outle and allow the wires to hang. Thread the wires through the center hole in back plate (B).
-
Attach fixture steel safety cable to structural member in the wall. (Refer to the illustration)
-
Attach ground (green) wire to ground wire from wall outlet box (usually green or copper in color ), fasten together with a plastic wire connector. Tightly wrap the wire connector with electrical tape. so the end of the connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED. -
Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white ) outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the wire connector with electrical tape.
-
Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE COMPROMISED. -
Attach fixture base (E) to back plate (B) and secure by inserting base screws (F).
-
INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/OR IN WET LOCATION:
a. Mounting surface should be clean, dry, flat and 1/4″ larger than canopy/fixture base on all sides. Any gaps between the mounting surface and fixture base exceeding 3/16″ should be corrected as required.
b. With silicone (ex. GE-108) caulking compound, caulk completely around where back of canopy/fixture base meets the wall surface to prevent water from seeping into outlet box.
TO AVOID WATER ENTERING THE FIXTURE BASE FROM THE SIDE OF FIXTURE, THIS FIXTURE MUST BE MOUNTED ABOVE 1.2M (4 FT) FROM THE GROUND.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>