GLASSDOME GLASS-PLC-GW2 LPWAN IoT Gateway User Manual
- June 13, 2024
- GLASSDOME
Table of Contents
GLASSDOME GLASS-PLC-GW2 LPWAN IoT Gateway User Manual
Introduction
GLSD-PLC-GW-2 is ARM Cortex-A based hardware platform
The Glassdome GLSD-PLC-GW-2 Industrial Gateway is LPWAN IoT gateway design for
smart Industrial 4.0 applications.
This LPWAN IoT gateway can aggregate both the wireless sensor networks (WSN)
Specification
| Processor System | CPU | Quad-Core Cortex-A55 (2.016GHz) |
|---|---|---|
| Memory | DDR | DDR4 4GiB with 32-bit bus width |
| Ethernet | LAN | 1 x 10/100/1000Mbps |
| COM(Serial) | H/W | RS-232, RS-485 |
| ModBus | ModBus TCP / RTU Translator | |
| Connectivity | LoRa | 915MHz |
| Cellular | 4G LTE-FDD B2 / B4 / B12, WCDMA B2 / B4 / B5 | |
| Antenna | LoRa | 902 ~ 928MHz @ 3.5 dBi |
| Cellular | 824 ~ 2200MHz @ 3.5 dBi | |
| Dimensions | W x L x T | 140mm x 139mm x 45mm |
| Power | DC-In | 12V DC-In |
| Environment | Operational Temperature | -20 ~ 70 °C |
| Certifications | Level | FCC / Class A |
Hardware Views
Dimensions
Safety Instructions
- Keep this equipment away from humidity
- Put this equipment on a reliable surface during installation. Dropping it or letting it fall may cause damage
- Liquid has penetrated into the equipment
- The equipment has been exposed to moisture
- The equipment has been dropped and damaged.
Declaration of Conformity
FCC
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device that are
not expressly approved by the manufacturer may void the user’s authority to
operate the equipment.
FCC and IC RF Radiation Exposure Statement: This equipment complies with FCC
and IC RF Radiation exposure limits set forth for an uncontrolled environment.
This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body
ISED
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Website Introduction
www.glassdomeinc.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>