PHILIPS hue Wall Switch Module User Manual
- May 15, 2024
- Philips
Table of Contents
**PHILIPS hue Wall Switch Module User Manual
**
INSTALLATION INSTRUCTION
Work on Electrical installations is in some countries only allowed by a quali�ed electrician. For support contact a local electrician or authority to install the product in accordance with national and electrical codes.
The electrical circuit and attached light source will always be powered after installation, turn off the circuit breaker when replacing a light �xture / battery
Wire Connectors Instructions:
- Turn off power before installing or removing connectors.
- Strip wires 5/16″(7.9mm). For #16 and smaller wires, strip 3/8″(9.5mm).
- Pre-twisting unnecessary, hold stripped wires together with ends even.
- Push wires into connector and screw on until two twists are visible in wires.
For use with copperto copper conductor
Temperature Rating: 105°C (221 °F) Max.
Voltage Rating: 600V Max. building wiring; 1000V Max. in fixtures and
signs Listed as a PRESSURE-TYPE wire connector on the following Solid wire
combinations: For UL Listed, CSA Certified
Note
NOTE
INSTALLATION
NOTE
Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater, NJ 08807, USA
Signify Canada Ltd./Signify Canada Ltée.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Questions or Comments / Questions ou commentaires :
800-508-9000
Importado y/o distribuido en México por:
Signify Mexico S.A. De C.V.
Av. La Palma No. 6,
La Herradura, Huixquilucan,
Edo de México, C.P. 52784,
México RFC PME-620620-E84
Centro de contacto: 800-508-9000
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>