Cameo Shores 73320-66A 1 Light Black Outdoor Wall Mount Instruction Manual
- June 13, 2024
- Cameo Shores
Table of Contents
Cameo Shores 73320-66A 1 Light Black Outdoor Wall Mount
Product Information
The product is an electrical fixture, item number 73320/73321-66A, manufactured on December 30, 2022. It comes with installation instructions and a cautionary warning to shut off power at the fuse or circuit breaker before installation. The fixture includes a mounting plate, ground screw, mounting screws, fixture wires (black or smooth, white or ribbed, and bare copper), and house wires (black, white, and green).
Product Usage Instructions
- Start by shutting off the power at the fuse box or circuit breaker.
- Remove the old fixture and its mounting hardware.
- Unpack the new fixture and ensure all parts are present.
- Attach the mounting plate to the junction box using the provided mounting screws. Make sure the side marked “GND” faces outward.
- Connect the electrical wires according to the diagram in Figure 2. Ensure all wire connectors are securely fastened. If your junction box has a ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the provided green screw.
- Tuck the wire connectors neatly inside the junction box.
- Place the fixture body onto the mounting plate, followed by the plastic washer, and secure with screws.
- To prevent moisture from entering the outlet box, caulk around the back plate if necessary.
- Complete the installation by turning on the power at the fuse box or circuit breaker.
- Test the fixture to ensure it is functioning correctly.
Note : The illustration in Figure 1 is for installation purposes only and may not be identical to the purchased fixture.
INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig. 1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
- Attach mounting plate (A) to junction box (not included) using mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
- Connect the electrical wires as shown in figure 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to mounting plate (A) using green screw provided.
- Tuck wire connectors neatly inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
- Place fixture body (D) onto mounting plate (A) followed by plastic washer (E) and secure with screws (C).
- To prevent moisture from entering outlet box and causing a short, use clear caulking (i.e. Indoor/Outdoor Silicone Sealant) to outline the outside of fixture back-plate where it meets the wall leaving a space at bottom to allow moisture a means to escape (Fig.3).
- Install (1) one candelabra base bulbs (G) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
- DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
- Place glass shade (H) over socket (F) and twist until secured on socket cup.
Your installation is now complete. Return power to the junction box and test the fixture.
Note : Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
LA-3634E
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>