INVENTUM GF461B Cold Zone Deep Fryer Instruction Manual

: June 13, 2024
: INVENTUM

Table of Contents

Safety instructions
Appliance description
Before the ﬁrst use
Frying
After frying
Tips
Cleaning & maintenance
General terms and conditions of service and warranty
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

COOLZONE FRYER
GF461B INVENTUM GF461B Cold Zone Deep Fryer

Instruction manual

Safety instructions

Please read these instructions before operating the appliance and retain for future use.
Attention: The capacity of this double fryer is 2 x 1800 Watts. Therefore check the maximum of your electric circuit before you plug in both fryers.
The appliance is intended solely for domestic use within the home.
Attention! Avoid touching hot surfaces, especially the outside of the appliance when the appliance is in use.
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
Never let the power cord of the appliance hang over the edge of a table or counter, touch hot surfaces or become knotted.
Never place this appliance on or near a hot gas or electric burner or where it could touch a heated oven or microwave. Do not allow this appliance to touch curtains, wall coverings, clothing, dishtowels or other flammable materials during use.
Always use the appliance on a secure, dry, level surface.
Never leave the appliance unattended when in use.
Remove the lid from the deep fat fryer during use.
Always carry out regular checks of the power cord to ensure no damage is evident. Should there be any signs that the cord is damaged in the slightest degree, the entire appliance should be returned to the Customer Service Department. For your own safety, only use the accessories and spare parts from the manufacturer which are suitable for the appliance.
For your own safety, only use the accessories and spare parts from the manufacturer which are suitable for the appliance.
Always return the appliance after a malfunction, or if it has been damaged in any manner to the Customer Service Department for examination, repair or adjustment as special purpose tools are required.
Never unplug it from the socket by pulling on the cable.
Always ensure that your hands are dry before handling the plug, switch or power cord.
The appliance is not intended to be operated by means of an external timer or a separate remote-control system.
This appliance shall not be used by children from 0 to 8 years. This appliance can be used by children over the age of 8 and above if they are continuously supervised.
This appliance can be used by people with reduced physical, sensory or mental capabilities or lack of experience or knowledge, if they have been given supervision or instruction concering use of the appliance in a safe way and understand the hazards involved. Keep the appliance and its cord out of reach of children aged less than 8 years.
Cleaning and maintenance shall not be made by children.
Children should be supervised to ensure that they do not play with the appliance.
Unplug the appliance as soon as you have finished using it and when you are cleaning it.
Ensure the lid and the reservoir do not contain any water before filling the fryer with oil.
Should you decide not to use the appliance anymore, make it inoperative by cutting the power cord after removing the plug from the socket. We also recommend making all potentially dangerous parts of the appliance harmless, particularly for children who might be tempted to play with it.
Never use the appliance if it is not working properly, or if it has been damaged. Any intervention other than cleaning and normal maintenance by the customer must be carried out by an approved service centre.
Never immerse any part of the main body, lid, power cord and plug in water or any other liquid to protect against electrical hazards.
This appliance is intended to be used in household and similar applications such as:
– staff kitchen areas, in shops, offices and other working environments;
– by clients in hotels, motels and other residential type environments;
– Bed and Breakfast type environments
– farm houses.
If the appliance is used for other purposes than intended, or is it not handled in accordance with the instruction manual, the full responsibility for any consequences will rest with the user. Any damages to the product or other things are not covered by the warranty.
Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling.
Electrical and electronic equipment marked with the symbol indicating seperate collection of such equipment must be returned to a municipal waste collection point.

Appliance description

Heating element
Lid
Basket with handle
Exterior
Handle – exterior
Reset-button
Storage for power cord
Control lamp – red
Thermostat button
Thermostat lamp – green
Reservoir – enameled

Before the ﬁrst use

Attention: The capacity of this double fryer is 2 x 1800 Watts. Therefore check the maximum of your electric circuit before you plug in both fryers.
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any visible damage, possible from transportation. Place the appliance on a stable and heat resistant surface.
Remove the lid and the basket. Take out the heating element by pulling it straight up and also remove the reservoir.
Clean the lid, the basket and the reservoir with warm soapy water. Dry the parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior with a damp cloth and dry thoroughly. Assemble the fryer.
Fill the reservoir with liquid frying oil between the minimum and maximum level, approx. 2,5 liters. Ensure that you don’t add less than the minimum capacity or over the maximum capacity. Inside the reservoir you will find two lines which indicate the minimum and maximum level.
Attention: this fryer may only be used with liquid frying oil. Never use hard fats.
The handle of the basket can be stored in the basket by folding it in. Squeeze the two handle wires together and push the handle forwards over the locking clip.
Only store the handle when the oil is fully cooled down. Ensure the handle is folded back before operating the fryer again!
For the best result in a cool zone fryer, always fry without using the lid.

Frying

Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance and plug the fryer in.
Check if the handle is folded back and turn the fryer on by plugging it in. The red power indicator will light up.
Turn the thermostat button clockwise to the required temperature.
The green thermostat lamp will light up.
Note: always remove the handle out of the oil before heating, otherwise the plastic handle will melt.
As soon as the desired temperature is reached, the green thermostat lamp goes out. The thermostat and the thermostat lamp will toggle on and off as the thermostat in the fryer maintains the correct temperature.
The fryer is now ready to use.
Add the desired quantity of food to the basket. Do not add too much food at one time (never more than 2/3).
Food should be as dry as possible to reduce the amount of water getting into the oil. Shake the ice off of frozen products above the sink.
Lower the basket slowly into the oil. If you lower too fast the oil can splash.
Always fry without the lid. This prevents the fryer from overheating and an automatic shutdown. At the same time it ensures a crispier result.
When the food is deepfried, lift the basket out of the oil. Carefully shake the excessive fat of and hang the basket on the hook in the reservoir to drain the oil.
Take the basket out of the fryer and serve the food.
Place the basket back.

After frying

When you have finished frying, turn the fryer off by turning the thermostat button anti-clockwise completely and pull the plug from the socket.
Only store the handle when the oil is fully cooled down. Ensure the handle is folded back before operating the fryer again!
Let the fryer cooldown for several hours before moving the fryer. If you want to move the fryer always use both hands.

Tips

Note: during and after frying it is possible that drops of condensated water fall into the hot oil. The hard noise you can hear, is the reaction of the water with the oil/fat and is normal. It does not influence the use of the fryer.
Note: Battered or coated food, like fish, may stick to the basket. To prevent this, lower the basket and than place the food in the fryer.
Never salt the product before or during cooking. This will soil the oil.
For the best results it is advisable not to fry with a full basket, maximum 450 to 500 grams. Fry frozen products in even smaller portions, because they contain more water and cause the oil to cool down too much.
If you make your own fries, dry them thoroughly after washing to make sure there will be no water in the oil. Fry the fresh fries in two times. The first time (pre-cooking) 5 to 10 minutes on 170 degrees. Lift the basket, let the oil drain and let the fries cool down for several minutes. For the second time turn the temperature control (cooking) to 190 degrees and cook the fries in 2 to 4 minutes. Lift the basket after frying and let the oil drain.

Safety

Your fryer is provided with a double safety, a reset-button and a safety switch.
The fryer is provided with an overheatingsafety which automatically shuts the fryer off when overheating. Remove the plug from the outlet and allow the fryer to cool down completely. You can switch the fryer on again when you push in the resetbutton on the back in the storagecompartment. See 6 on the picture. Use a blunt object topress the reset-button in the small round opening.
On the front of the heating you will see a safety switch. If you pull out the heating element while the fryer is still on, the safety switch will shut the element of. This also means that you can not use the heating element when it is not placed or not placed correctly in the retaining slots.

Cleaning & maintenance

FILTERING OR CHANGING LIQUID FRYING OIL
Before changing or filtering the oil, always unplug the fryer and let it cool down completely. The liquid frying oil can be used longer, if you filter it regularly. Replace the liquid frying oil regularly, after 8 to 12 times.
Filter the liquid frying oil only when it is cold. Pour the oil in a clean bowl. Clean the reservoir with hot water and a mild detergent or in the dishwasher. Thoroughly dry the reservoir.
Pour the liquid frying oil back in the reservoir through a fine sieve.
Check each time if the level of the liquid frying oil is between the minimum and maximum level. When replacing the oil, follow the same steps as described before. Liquid frying oil can be poured back in the bottles. Never wash away fat or oil through the sink.
CLEANING THE FRYER
Before cleaning always unplug the fryer and let it cool down completely. Remove the basket, the element and the reservoir out of the fryer. Clean the lid, the basket and the reservoir in the dishwasher or with hot water and a mild detergent. Ensure that the parts are dried thoroughly after cleaning.
Clean the exterior of the fryer with a damp cloth and when needed a mild detergent.
Never use any abrasives! Never immerse the heating element, power cord or plug in water or other liquids.

General terms and conditions of service and warranty

We do not need to remind you of the importance of service. After all, we develop our products to a standard so that you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are entitled to a solution straight away. Hence our products come with an exchange service, on top of the rights and claims you are entitled to by law. By exchanging a product or part, we save you time, effort and costs.
2-year full manufacturer’s warranty

Customers enjoy a 2-year full manufacturer’s warranty on all Inventum products. Within this period, a faulty product or part will always be exchanged for a new model, free of charge. In order to claim under the 2-year full manufacturer’s warranty, you can either return the product to the shop you bought it from or contact the Inventum costumer service department via the form at www.inventum.eu/service-aanvraag.
The 2-year warranty period starts from the date the product is bought.
In order to claim under the warranty, you must produce a copy of the original receipt.
The warranty applies only to normal domestic use of Inventum products within the Netherlands.

Breakdowns or faults outside the warranty period

Breakdowns or faults in small or large domestic appliances outside the warranty period, can be reported to the costumer services department via the form at www.inventum.eu/service-aanvraag or by calling the costumer services department.
The costumer services department may ask you to send the product for inspection or repair. The costs of dispatch will be at your expense.
The inspection to establish whether repair is possible involves a charge. You need to grant your permission for this, in advance.
In the event of a large domestic appliance, Inventum, at your request, can send out a service engineer. In that case, you will be charged the call-out costs, as well as parts and labour.
In the event of an instruction to repair, the repair costs must be paid in advance. In the event of a repair by a service engineer, the costs of the repair must be settled with the engineer onsite, preferably by means of PIN payment.

Warranty exclusions

The following is excluded from the aforesaid warranties:
• normal wear and tear;
• improper use or misuse;
• insufficient maintenance;
• failure to comply with the operating and maintenance instructions;
• unprofessional installation or repairs by third parties or the customer himself;
• non-original parts used by the customer;
• use for commercial or business purposes;
• removal of the serial number and/or rating label.
In addition, the warranty does not apply to normal consumer goods, such as:
• dough hooks, baking tins, (carbon) filters, etc.;
• batteries, bulbs, carbon filters, fat filters etc.;
• external connection cables;
• glass accessories and glass parts such as oven doors;
• and similar items.
Transport damage not caused by Inventum is also excluded. Therefore, inspect your new device before starting to use it.
If you detect any damage, you must report this to the store where you purchased the product within 5 working days, or to the Inventum customer service department via the form at www.inventum.eu/service-aanvraag. If transport damage is not reported within this period, Inventum does not accept any liability in this respect.
The following are excluded from warranty and/or replacement: faults, loss of and damage to the device as a result of an event that is normally insured under the home contents insurance.

Important to know

The replacement or repair of a faulty product, or a part thereof, does not lead to an extension of the original warranty period.
If a complaint is unfounded, all costs arising from it will be at the customer’s expense.
Following expiry of the warranty period, all costs of repair or replacement, including administration costs, dispatch and call-out charges, will be charged to the customer.
Inventum cannot be held liable for damage caused by external events, unless this liability arises from mandatory statutory provisions.
These warranty and service provisions are governed by Dutch law. Disputes will be settled exclusively by the competent Dutch court.