snow peak CK-304 TTA Side Tray Instruction Manual

Specifications

• Material(s): Stainless steel, silicon rubber
• Size: φ200×28(h)mm / dia 7.9”×1.1”(h)
• Weight: 370g / 13 oz
• Load bearing capacity: 1kg / 2.2 lbs
  • To be installed on top
  • To be installed on the bottom
  • To be installed on the both top and bottom side

Safety Precautions: Before use, please read thoroughly to ensure safety and avoid accidents.

DANGER: Misuse could easily result in a serious accident or death.

• Keep an eye on small children if they are nearby. If children play with this product, it may result in unexpected accidents.
• Be sure to use the CK-300 clamps (sold separately) to fix this product to a table. If you use other means, the product may fall, resulting in personal injury or product damage.

DANGER: Misuse could easily result in a serious accident or death.

• Before using the product, check each part for abnormalities. If there are abnormalities, take the product to the dealer or Snow Peak Customer Service for inspection or repair.
• Do not use this product near heat sources such as a burner or petroleum equipment. Doing so will heat this product up, which will make it a hazard.

CAUTION:Misuse could result in injury to the user and/or damage to property.

• Be careful not to cut your hand on the edge of the threaded portion.
• After assembly, check for wobbling, and loose screws and clamp bolts. Also, regularly check the screws and bolts for looseness during use. If this product is used while it is wobbly or screws and bolts are loose, parts may fall off or objects may fall, which may result in personal injury or product damage.
• Do not use this product if it cannot be assembled as described in the Instruction Manual due to deformation or rust. If this product is used for a long period of time, it may become deformed or rust, which may prevent screws from turning smoothly or cause the product to become unstable when assembled. If you continue to use this product in such a state, it may fall apart or parts may come off, which may result in personal injury or product damage.
• Please note that this product becomes hot if used in a place exposed to direct sunlight for a long period of time, particularly under scorching sun.
• When using this product outdoors, use it in a place where it will not be exposed to rain, such as under a tarp. If you leave this product wet with rainwater for a long period of time, the screws and joints may rust, which may lead to discoloration and sticking.
• Do not assemble or disassemble this product when it is wet or with wet hands. Otherwise, an injury may result.
• The product should be assembled by a person who is capable of understanding the Instruction Manual, has a sufficiently strong grip, and who has the ability to assemble it correctly.
• Do not exert pressure or force on the side tray from above. Excessive force may damage the product and cause injury around the product.
• Use only within the maximum load (1kg / 2.2 lbs). Failure to do so may result in injury or damage to the product.
• While this product is attached, do not attempt to adjust the attachment position, or move it. If you loosen the clamp while the product is being assembled, the product may fall off, which may result in personal injury or product damage.
• When transporting this product, use a soft cloth to protect the screws before storing it. If the screws are exposed, they may come in contact with other products, resulting in damage to the screws.
• Use this product on a flat and stable surface. If it is used on an angled or unstable surface, the product may fall, resulting in personal injury or product damage.Also, read the instruction manual for the table, and use this product correctly.
• After assembling this product, check that it does not easily come off the table.
• This product is not intended for permanent use. Clean this product immediately after use, and keep it out of the reach of children.
• Do not place food directly on the tray. This product is not a plate and is not intended for food.
• The tray should always be used with the logo visible on the top surface. If the product is placed upside down, it may be damaged or cause injury to the user.
• Do not use near fire, flames or gas appliances. Additionally, do not use it with a gas lighter or anything that produces flames.
• Do not place hot items directly on the tray. Doing so may cause burns.

Instructions for Use

This product is designed to be attached to the CK-300 clamp (sold separately). Please read the instruction manual for the CK-300 clamp carefully before assembly.

1. Be sure to check that the tray does not wobble by moving the CK-300 clamp. Next, hold the fixing nut and lightly tighten the fixing shaft clockwise until it comes to the position of the base of the screw.
2. Align the holes of the tray with the screw holes of the CK-300 clamp, and screw the fixing shaft with the nut noted in step ① clockwise into the screw holes of the CK-300 clamp. Tighten until secure.
3. After tightening the fixing shaft screw completely, align the tray to the desired position. Once aligned, screw the fixing nut clockwise until the tray stops moving, then tighten.
4. Install the protection cap on the tip. Finally, check to make sure that there are no loose parts.
5. To remove the tray, follow the procedure in reverse order. If you wish to change the position of the tray after installation, loosen the fixing nut and repeat the procedure from step ③.

Caution: Forcibly changing the direction of the tray may damage it. Also, if you turn the tray too far in the closing direction, you may not be able to remove the fixing nut.

• This figure shows the tray’s movable range when attached to the top of the clamp. The tray can be rotated only within the gray area as shown in the figure below because the arm bracket is against the clamp.

Maintenance and disposal

• After use, follow the procedure described below to appropriately clean and store the product. Not cleaning dirt or moisture off the product may cause rust to form.
• After use, disassemble the product and clean it using a dry cloth.
• If the product is wet, disassemble it, wipe it, and dry it well.
• If salt, seasonings, or other substances are adhered to the product, wipe them off thoroughly using a tightly wrung cloth and allow it to dry thoroughly.
• If you use this product in a location exposed to sea breezes such as a beach, disassemble it, wipe it thoroughly using a tightly wrung cloth, and dry it well.

CAUTION
Be careful not to cut your hand on the edge of the threaded portion.

• When disposing of this product, follow the rules of the local government of your area.

Warranty

Snow Peak has taken all possible measures to ensure every product is durable and functions correctly. If you find any product defects, please contact the retailer where you purchased the product or Snow Peak Customer Service. If there are apparent defects in the product’s manufacturing, the defective product will be repaired or exchanged free of charge. In other cases, Snow Peak will repair the product for an appropriate fee. The decision to repair or replace the product will be at our discretion. Snow Peak will not repair the product for any damage that occurred due to the following: 1.Material deterioration caused by age / 2.Damage caused by modifications or rough handling / 3.Damage caused by inappropriate use not mentioned in the instruction manual / 4.Damage caused by unexpected accidents / 5. Any damage other than defects in the manufacturing process / 6.Damage caused by dust or rust / 7.Damage and defects caused by dismantling the product / 8.Damage and defects caused by dropping, jolting or other shocks / 9. Deterioration or failure of parts due to friction / 10. Damage caused by the use of the product in combination with another manufacturer’s products.

Repair

• If professional repairs are required, please contact the retailer where you purchased the product or Snow Peak Customer Service.
• When you request repairs, please make sure that the product is dry and clean.
• Please attach a memo or a tag indicating the necessary repair and please write details of how and when the damage occurred.
• Transportation and repair costs are determined as follows: 1.Within warranty: The transportation cost (both ways) and repair cost will be covered by Snow Peak. / 2.Outside warranty: The transportation cost (both ways) and repair cost will be covered by the customer.

Snow Peak USA, Inc.
404 NW 23rd Avenue, Portland, Oregon 97210, USA Tel. +1 503-461-0781 / Instagram. @snowpeakusa Email. info@snowpeak.com / www.snowpeak.com

Snow Peak, Inc.
456, Nakanohara, Sanjo-Shi, Niigata 955-0147 Japan Tel. +81 256-46-5858 / Fax. +81 256-46-5860 www.snowpeak.co.jp

References

• スノーピーク ＊ Snow Peak
• Snow Peak USA - Japanese-Designed Camping Gear & Apparel – Snow Peak

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>