RETEKESS TD032 Pager User Manual
- June 8, 2024
- RETEKESS
Table of Contents
RETEKESS TD032 Pager
OVERVIEW
Product introduction
The power supply voltage of the TD032 Pager is 12V, and the crystal oscillator is 26MHz. One end of the button is connected to GND, and the other end is connected to the IO port of the single-chip microcomputer. When the button is pressed, the IO port of the corresponding single-chip microcomputer is pulled down
Technical data
- Working frequency: 433.92MHz
- Encoder: Learning code
Packing List
- Transmitting host: 1 pcs
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
- The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.