SIGNATURE HARDWARE 440455 Beatty Chandelier Gloss User Guide
- June 13, 2024
- Signature Hardware
Table of Contents
BEATTY
CHANDELIER
LUSTRE
SKU: 440451, 440453, 440455
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer Relations team via live chat at
www.signaturehardware.com or by emailing
[email protected].
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for
the installation.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.
TOOLS AND MATERIALS:
INSTALLATION (FIG. 1)
- Thread rod (L) into coupling (M). Carefully pass the wires through each rod during assembly. Repeat step 1 with rods (G), (H), (I), (J) and (K) until the desired hanging height is reached.
- Thread the rod (G) onto coupling (F).
INSTALLATION (FIG. 2)
-
Thread the mounting screws (A) into the matching holes in the mounting bar (B).
-
Secure mounting bar (B) to the outlet box with outlet box screws (C).
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the mounting bar.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected, tuck them carefully inside outlet box. Raise the canopy (D) allowing for the mounting screws (A) to protrude through the holes on canopy (D), and secure with the ball nuts (E).
-
Place the shade (S) onto the candle sleeve (R).
-
Install light bulbs (T) (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket.
1.855.715.1800
signaturehardware.com