SIGNATURE HARDWARE 944727 Flush Mount Light Instruction Manual
- June 13, 2024
- Signature Hardware
Table of Contents
SIGNATURE HARDWARE 944727 Flush Mount Light
BEFORE YOU BEGIN GETTING STARTED
We recommend consulting a professional if you are unfamiliar with installing electric fixtures. Signature
Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer
Relations team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you a reworking on is shut off. either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wi res. nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. if you are unclear as to how to proceed. consult a qualified electrician.
TOOLS AND MATERIALS
-
Light Bulb (Al9 100 watt maximum)
-
Safety Glasses
-
Wire Stripper
-
Step Ladder
-
Phillips Screwdriver
-
Flathead Screwdriver
-
Wire Cutters
-
Electrical Tape
INSTALLATION
(FIG. 1)
-
Thread the mounting screws (C) into the matching holes in the mounting bar (B)
-
Secure mounting bar (B) to the outlet box with outlet box screws (A).
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect he copper ground wires from the fixture and from the outlet box to the ground screw on the mounting bar.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected. tuck them carefully inside outlet box. Raise the canopy (D) allowing for the mounting screws (C) to protrude through the key slots.
Rotate the canopy (A) clockwise until the mounting screws (C) are in the narrow part of the key slots. and tighten with a screwdriver.
(FIG. 2)
- Place the glass (H) on the bottom of the metal ring (E) then using the sheet metals (G) to compact the glass (H)
- Install light bulbs (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket. We recommend the use of a clear light bulb.
- Raise the metal ring (E) to the canopy (D) and secure with the screws (F).
CUSTOMERS SUPPORT
1.855.715.1800
signaturehardware.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>