DORNBRACHT 12 892 970 90 Brushed Platinum Hot and Cold Water Dispenser User Manual
- June 13, 2024
- DORNBRACHT
Table of Contents
Installation instructions
Operating Manual
12 892 970 90 / 12 893 970 90 /
17 861 625-FF / 17 861 680-FF /
17 861 790-FF / 17 861 875-FF / 17 861 888-FF
12 892 970 90 Brushed Platinum Hot and Cold Water Dispenser
Please pass these instructions on to the end user.
General safety instructions.
WARNING! This symbol warns of the possibility of death or serious injury
due to non-compliance with the safety instructions.
ATTENTION! This symbol warns of property damages due to non-compliance
with the instructions.
NOTICE! This symbol calls attention to important information.
All the work must be carried out exclusively by competent, suitably qualified
personnel!
Only then can there be any assumption of liability on the part of the
manufacturer. Priority is always given to national statutory accident
prevention regulations. Electrical installation must be carried out by a
professional specialist, in accordance with VDE 0100. Please conform to
national statutory regulations, where different. For questions or
uncertainties regarding installation or operation, please contact the
Technical Service of Dornbracht. Operating conditions and dimensions can be
found in the appendix.
**** The HOT & COLD WATER DISPENSER must only be installed in conjunction
with the Insinkerator® ! hot water tank and filter components (12 892 970 90 /
12 893 970 90). The devices are not designed for outdoor use. The filter must
be replaced every six months, the HOT & COLD WATER DISPENSER and its
components must be serviced by a qualified installer every five years, to
ensure that it works properly. Use only original spare and miscellaneous
parts. If any other parts are used, this will invalidate the warranty and may
cause injury. The HOT & COLD WATER DISPENSER is not intended for commercial
use. It was designed for use in the home, and for household-like use. When
filling with hot water, use suitable, heat-resistant containers made from
materials such as glass or ceramics.
The HOT & COLD WATER DISPENSER is not intended for use by children or persons
with limited physical, sensory or mental capabilities, unless they are
supervised by a person responsible for their safety.
Risk of scalding! When the HOT & COLD WATER DISPENSER is being used, the
temperature of the emerging hot water may be as high as 96 °C. Be sure to
avoid touching the jet of water and any spray and dispense the hot water
carefully. A scald should be medically assessed and treated, if necessary.
Risk of burning! The hot water flowing through the HOT & COLD WATER DISPENSER
can heat up the spout. So avoid touching the rigid spout while dispensing the
hot water, as well as for 5 minutes afterwards. A burn should be medically
assessed and treated, if necessary.
To minimize the risk of fire as much as possible, also keep flammable
materials and highly flammable objects away from the HOT & COLD WATER
DISPENSER. This is the only way to ensure safe and reliable use of the system.
Technical information.
dornbracht.com > Professional
Care and maintenance by the user.
Insinkerator®
www.insinkerator.de
US / CA Insinkerator®
www.insinkerator.com
Parts supplied.
12 892 970 90 / 2013 —>
12 893 970 90 / 2013 —>
12 892 970 90 / 2018 —>
12 893 970 90 / 2017 —>
Installation Examples.
Operating Manual
Operating conditions
Ambient temperature | 10-35 °C |
---|---|
Cold water temperature range | 5-25 °C |
Minimum flow pressure | 3 bar |
Maximum flow pressure | 5 bar |
Recommended operating pressure | 3-5 bar |
At a resting pressure above 5 bar, a pressure reducer in accordance with DIN
1988 must be installed in the supply line to maintain noise levels in
accordance with DIN 4109.
We recommended that the HOT & COLD WATER DISPENSER needs a minimum flow
pressure of 3 bar to work perfectly in conjunction with Insinkerator®
components.
Voltage supply
12 89X 970 90
Input voltage | 220-240 V AC |
---|---|
Input frequency | 50-60 Hz |
Power consumption | 1300 W |
17 861 XXX-FF
Input voltage | 100-240 V AC |
---|---|
Output voltage | 12 V DC |
Input frequency | 50-60 Hz |
Maximum power consumption | 18 W |
Power consumption (in operation) | 5-10 W |
Power consumption (sleep mode) | 0,6 W |
Output current | 1.5 A |
Dornbracht AG & Co. KG
Köbbingser Mühle 6, D-58640 Iserlohn
Tel. +49 2371 8899-900, Fax +49 2371 433-232
mail@dornbracht.de
www.dornbracht.com
References
- goo.gl/yYrfOA
- Garbage Disposals | Instant Hot Water Dispensers | InSinkErator US
- Heißwasserhähne und Entsorger für Lebensmittelabfälle | InSinkErator DE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>