POWER ACOUSTIK SA-26 Spectrum Analyzer User Guide
- June 13, 2024
- POWER ACOUSTIK
Table of Contents
WHATS IN THE BOX
| 
|
---|---|---
Spectrum Analyzer| Mounting Bracket| Double-Sided Adhesive
| 
|
Power Cable| Mounting Screws| USB Cable
INSTALLING THE SPECTRUM ANALYZER
PowerAcoustik Spectrum Analyzer can be mounted on flat surfaces in your car
two ways:
Double Sided Adhesive
- Clean the surface area around the deisred location using a damp microfiber towel and mild detergent if necessary.
- Remove the protective paper from one side of the included double sided adhesive.
- Apply the exposed adhesive side to the back of the Spectrum Analyzer.
- Remove the protective paper from the opposite side of the double sided adhesive.
- Install the Spectrum Analyzer by firmly pressing the Spectrum Analyzer onto the desired mounting surface.
Angled Stand / Support Bracket
- Secure the angled support bracket to a flat surface using two provided course thread screws or apply the double sided adhesive to the bottom of the bracket.
- If using the double sided adhesive, remove the protective paper from the opposite side of the double sided adhesive & install the bracekt by firmly pressing it onto the desired mounting surface.
- Secure the Spectrum Analyzer to the angled support bracket using the provided fine thread screws into the back of the Spectrum Analyzer.
POWERING THE SPECTRUM ANALYZER
PowerAcoustik Spectrum Analyzer can be powered two ways:
USB Cable
- Insert the oval Typc-C end of the USB cable into the Type-C input on the left side of the Spectrum Analyzer.
- Connect the square Type-A end of the USB cable into an available USB Carging device.
Direct Power
- Insert the white end of the power cable into the power port on the back ofthe Spectrum Analyzer.
- Connect the red wire to positive power & the back wire to ground of the vehicles electrical system.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>