Lian Li SL-INF 240 GA II TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler Installation Guide
- June 13, 2024
- LIAN LI
Table of Contents
Lian Li SL-INF 240 GA II TRINITY Closed Loop ARGB AIO LIQUID CPU Cooler
Hardware List
Apply thermal paste
- Default Orientation
- Rotate Orientation
- The control film direction depends on the CPU, please follow the left reference to place the control film in a different tube orientation
Rotate the pump
- Peel the protective film
- Default Orientation
- Rotate Orientation
- In consideration of performance, only offer these 2 tubes’ outlet orientation
- Secure the AMD latch onto the platform’s retention clip and tighten it with a spring nut
Mount in the chassis
Customize pump cover
Remove the outer cover
Install the inner cover L & K
- Hold on top of the latch for easier positioning with force
- Place the latch in the slot and twist the inner cover to install properly
- Place the latch in the suitable slot and twist the outer cover to install properly
The cable connection of the pump
- Attention! The cable convex side on the interface shall face upward
Restriction of Controller
- Controller maximum outputs 22.5W.
- Control lighting effects with L-Connect 3: Please lower the brightness when set to static white.
- Sync lighting effects to the motherboard: Supports a maximum of 6 UNI FAN SL-INF fans when set at static white 100% brightness.
Fan removal
Steps to switch the orientation of the cable on the power module
Cable Connection Guide
- Warning! Do not connect the wrongtype of LED connector. If it is connected to the 12 V connector, permanent damage will occur
- Connection guide for extra UNI FAN SL-INF single-pack
Use of magnetic adhesive
G50.GA2T24-36IN.01
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>