marta MT-FH2529C Fan Heater User Manual

: June 13, 2024
: MARTA

Table of Contents

marta MT-FH2529C Fan Heater
Product Information
Product Usage Instructions
Parts list
BEFORE THE FIRST USE
USAGE
OVERHEAT PROTECTION
CLEANING AND MAINTENANCE
SPECIFICATION
Documents / Resources

marta MT-FH2529C Fan Heater

marta-MT-FH2529C-Fan-Heater-PRODUCT

Product Information

Product Name: Fan Heater
Model Number: MT-FH2529C
Manufacturer: Cosmos Far View International Limited
Power Supply: 230V ~ 50Hz
Producer Address: Room 701, 16 apt, Lane 165,
Rainbow North Street, Ningbo, China
Made in: China

Parts List

Housing
Air outlet
Mode control: Room temperature air / Warm / Hot wind
Power indication light
Thermostat knob

Cleaning and Maintenance

To ensure proper functioning and longevity of the fan heater, regular cleaning and maintenance are recommended. Refer to the user manual for detailed instructions.

Warranty Information

The warranty does not cover supplies such as filters, ceramic and non-stick coating, rubber seals, etc. The production date can be determined from the serial number on the gift box or the device itself. The manufacturer reserves the right to change the complete set, appearance, country of manufacture, warranty, and technical characteristics of the model without notice. For service center information, visit the website www.multimarta.com.

Product Usage Instructions

Before the First Use

Before using the fan heater for the first time, please ensure the following:

Read and understand the user manual.
Inspect the appliance for any visible damage.
Check that the power supply matches the specified voltage and frequency.

Usage

To operate the fan heater:

Plug the appliance into a suitable power outlet.
Set the mode control to your desired setting (Room temperature air / Warm / Hot wind).
Adjust the thermostat knob to achieve the desired temperature.
The power indication light will turn on when the appliance is in operation.

Overheat Protection

The fan heater is equipped with a safety device that will automatically switch off the heater in case of accidental overheating. If this happens:

Disconnect the plug from the power outlet.
Allow the appliance to cool down for a few minutes.
Remove any obstructions from the air intake and outlet grills.
Plug the appliance back in and resume normal operation.

Parts list

marta-MT-FH2529C-Fan-Heater-FIG-1

Housing
Air outlet
Mode control: Room temperature air
- Warm
- Hot wind
Power indication light
Thermostat knob

Real set of the appliance could be different from listed in the User manual. Check once buy.

CAUTION

Read this manual carefully before using the appliance and save it for future reference. When using electrical appliances, basic precautions should always be followed, including the following:
Before the first use, check the device specifications and the power supply in your network. Use the appliance only on the voltage specified on the identification plate.
It is not intended for industrial use. When store your heater, keep it in a cool, dry place.
Use the device in a well ventilated room with at least 1 meter of space on each side for normal air circulation and heat removal.
The appliance should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in the appliance if its surfaces are damp.
Do not allow the operating device to come into contact with fusible or flammable materials, fabrics, curtains, etc.
For indoor use only. Use only for domestic purposes according to the instruction manual. Do not use or store the unit in damp and moist areas where it may come in contact with water.
Do not place or use the unit on or near other household appliances (a hot gas or electric burner, etc.). To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
Do not use the appliance near explosives or flammable materials and easy deformed objects.
Do not use with damaged cord, plug or other injuries. Do not move the device by holding the cord.
Keep the power cord away from sharp edges and hot surfaces. Do not pull the cord. Always take the socket not the wire. Do not reel the cord around the device housing.
Never attempt to frame and repair the appliance by yourself. If you meet problems or if it has been dropped, or damaged in any manner, please contact the nearest customer service center.
Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
Place the appliance on a flat, stable and heat-resistant surface that can support the weight of the appliance.
Incorrectly assembled device may cause fire, electric shock or other injury.
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heater may emit some smell and fumes. This will disappear after a while.
DANGER: Do not cover the device with anything while it is in operation! Do not place any objects on it!
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
Do not touch the appliance, the power cord and the plug with wet hands! Do not insert and pull out the plug by wet hands, as this may cause electrical shock.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Keep out of the reach of children. Close supervision is required when any appliance is used by or near children.
Maximum allowable continuous operating time is 4 hours.
Unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use. Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD.
Danger of electric shock exists even when the appliance is switched off. ALWAYS unplug the unit when not in use.
WARNING: This device heats up during use. The temperature of surface may be exceeded when the appliance is in operation. The heater must always operate in vertical position.
Do not touch the hot surfaces or heating elements inside to avoid burns. Use handle, regulator and knob.
WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty service

BEFORE THE FIRST USE

Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.

USAGE

In order to avoid damage of the device, nothing should interfere the operation of air outlet. Provide free space of at least 1 m on each side.
Before connecting the device to the power supply, set the thermostat control to the extreme (minimum) position.
Connect the plug to the power supply.
Set the mode control to one of the three modes indicated below (the indicator light will light up):
Fan mode/Room temperature air” (room temperature air circulation without heating).
- Warm air” mode (the device heats the air at medium power).
- Hot air” mode (the device heats the air at maximum power).
Turn the thermostat control to the extreme (maximum) position.
The heating temperature is adjusted in two ways:

by rotating the thermostat knob: clockwise – to increase the temperature, counterclockwise – to decrease the temperature.
by setting various operating modes by the mode control.

DO NOT USE THE DEVICE FOR MORE THAN 4 HOURS WITHOUT INTERRUPTION.
To turn the device off, set the mode control to the position ‘’О’’, turn the thermostat control to the extreme (minimum) position, then disconnect the device from the power supply.

OVERHEAT PROTECTION

The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (e.g. obstruction of air intake and outlet grills, motor turning slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of overheating then plug the appliance in again.

CLEANING AND MAINTENANCE

Switch off the appliance and unplug it from the power supply and allow cooling down. Wipe the outside of the appliance with a soft damp cloth. Clean the air inlet/outlet grilles regularly.
Do not immerse the appliance in water or other liquids. Do not use any detergents or abrasives and do not allow any water to enter the heater.
When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.

SPECIFICATION

Producer:

COSMOS FAR VIEW INTERNATIONAL LIMITED
Room 701, 16 apt, Lane 165, Rainbow North Street , Ningbo, China
Made in China
Power supply 230 V ~ 50 Hz
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.)
Production date is available in the serial number located on the identification sticker on the gift box and/or on sticker on the device.
The serial number consists of 13 characters, the 4th and 5th characters indicate the month, the 6th and 7th indicate the year of device production.
Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice.
Please check when purchasing device.
Current information about service centers is available on the website www.multimarta.com