VICTOR M250S Electronic Mouse Trap Instructions
- June 13, 2024
- VICTOR
Table of Contents
Electronic Mouse Trap
Instructions
TRAP OPERATION INSTRUCTIONS
- Turn the switch to the “OFF” position and insert 4 AA batteries into the battery compartment.
- Open the kill chamber door and bait trap with peanut butter in the indicated bait cup.
- Turn the switch to the “ON” position. The green light will flash and the unit will buzz to indicate the unit has been enabled. Once a rodent is caught, a green light will flash for up to one week.
- Place the trap along a wall, making sure the side with the rodent entrance is against the wall.
A red light indicates low battery life. Replace batteries.
TO DISPOSE OF RODENT Turn the switch to “OFF”. Open the kill chamber door and
properly discard rodent.
TRAP CLEANING INSTRUCTIONS
- Disassembly: Turn the switch to “OFF”. Hold trap with battery compartment in left hand, power switch facing upwards and rodent entrance facing towards you.
- With your right hand push forward and separate the kill chamber from the electronics housing.
- The kill chamber is now ready for cleaning. Open rodent disposal door. Use soft bristle brush and warm soapy water to scrub inside of chamber if desired.
- Thoroughly dry interior and exterior of kill chamber prior to trap reassembly.
- Assembly: Hold battery compartment in left hand with power switch facing upwards and align key holes. Insert keys into opposite openings and pull right hand backwards to reconnect halves.
- Trap is ready for use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>