SONOFF S55 Wi-Fi Smart Waterproof Socket Installation Guide
- June 13, 2024
- SonOFF
Table of Contents
SONOFF S55 Wi-Fi Smart Waterproof Socket
Power off
To avoid electric shocks, please consult the dealer or a qualified professional for help when installing and repairing.
install socket
Fix screw anchors and mount the socket onto the wall with screws.
Wiring instruction
Take the waterproof rubber stopper out before wiring, then punch holes and feed in wires.
Make sure correct wiring and install the waterproof rubber stopper into the socket.
Install upper cover
Attach the upper cover and open the waterproof cover, then fasten it to the bottom cover with screws.
Download the eWeLink App
Power on
After powering on, the device will enter the Pairing Mode during the first use. The Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
The device will exit the Pairing Mode if not paired within 3mins. If you want to enter this mode, please long press button for about 5s until the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
Add device
Tap “+” and select “Add Device”, then operate following the prompt on the App.
https://www.sonoff.tech/usermanuals
Scan the QR code or visit the website to learn about the detailed user manual and help.
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
WEEE Warning
WEEE Disposal and Recycling Information All products bearing this symbol are
waste electrical and electronic equipment (WEEE as in directive
2012/19/EU)which should not be mixed with unsorted house hold waste. Instead,
you should protect human health and the environment by handing over your waste
equipment to a designated collection point for the recycling of waste
electrical and electronic equipment, appointed by the government or local
authorities. Correct disposal and recycling will help prevent potential
negative consequences to the environment and human health. Please contact the
installer or local authorities for more information about the location as well
as terms and conditions of such collection points.
TX Frequency:
WiFi: 2412-2472MHz
RX Frequency:
WiFi: 2412-2472MHz
Output Power: 17.18dBm(802.11b), 15.48dBm(802.11g), 15.35dBm(802.11 n20)
Shenzhen Sonoff Technologies Co., Ltd. 1001. BLDG8. Lianhua Industrial Park.
shenzhen. GD. China ZIP code: 518000
Website: sonoff.tech
Service email: support@itead.cc MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>