PHILIPS SCF65X Avent Natural Baby Bottle User Guide

: June 13, 2024
: Philips

Table of Contents

SCF65X Avant Natural Baby Bottle
Before first use
Cleaning
Assembly
Compatibility
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SCF65X Avant Natural Baby Bottle
User Guide

SCF65X Avant Natural Baby Bottle

SCF65X
SCF69X PHILIPS SCF65X Avent Natural Baby Bottle -
feager

For your child’s safety and health Warning!
– Always use this product with adult supervision.
– Never use feeding teats as a soother.
– Continuous and prolonged sucking of fluids will cause tooth decay.
– Always check food temperature before feeding.
– Heating in a microwave oven may produce localized high temperatures.
Take extra care when you heat up food in a microwave. Always stir heated food to ensure even heat distribution and test the temperature before serving.
– Keep all components not in use out of the reach of children.
– Do not allow child to play with small parts or walk/run while using bottles or cups.
– Do not place in a heated oven.
– Drinks other than milk and water, such as fruit juices and flavored sugary drinks are not recommended. If used, they should be well diluted and only used for limited periods.
– Do not use abrasive cleaning agents or anti-bacterial cleaners. Do not place components directly on surfaces that have been cleaned with anti-bacterial cleaners.
– Expressed breast milk can be stored in sterilized Philips Avant bottles/containers in the refrigerator for up to 48 hours (not in the door) or in the freezer for up to 3 months. Never refreeze breast milk or add fresh breast milk to already frozen milk.
– Plastic material properties may be affected by sterilizing and high temperatures. This can affect the fit of the cap.
– Do not use handles with glass bottles.
– Throw away any part at the first signs of damage or weakness.
– Do not alter the product or parts of it in any way. This may result in unsafe functioning of the product.
Teat
– Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness.
– For hygiene reasons, we recommend replacing teats after 3 months.
– Keep teats in a dry, covered container.
– Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant.

Before first use

Before first use, disassemble all parts, clean and sterilize the product.
Clean to ensure hygiene by washing and rinsing all parts thoroughly.
Sterilize by using a Philips Avant sterilizer or boil all parts for 5 minutes. This is to ensure hygiene.
During sterilizing with boiling water, prevent the bottle or other parts from touching the side of the pan. This can cause irreversible product deformation or damage that Philips cannot be held liable for.
Inspect the feeding teat before use and pull the feeding teat in all directions. Do not use damaged products.

Cleaning

After every use, take all items apart, wash in warm soapy water and rinse thoroughly. Make sure that you wash your hands thoroughly and that the surfaces are clean before contact with sterilized components.
Excessive concentration of detergents may eventually cause plastic components to crack. Should this occur, replace immediately.
Dishwasher safe – food colorings may discolor components.
Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant (‚sterilizing solution‘) for longer than recommended, as this may weaken the teat.
Clean all parts before each use.
Inspect the bottle and feeding teat before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness of any part.

Assembly

When you assemble the bottle, make sure you place the cap vertically onto the bottle so that the teat sits upright (see image for more details). To remove the cap, place your hand over the cap and your thumb in the dimple of the cap. The teat is easier to assemble if you wriggle it upwards instead of pulling it up in a straight line. Make sure you pull the teat through until its lower part is even with the screw ring.

Maintenance

Before each use, inspect all items. Pull the feeding teat in all directions.
Throw away any part at the first signs of damage or weakness.
For hygiene reasons, we recommend replacing teats after 3 months.
Keep teats in a dry, covered container.
When not in use, do not leave in sunlight or heat, or leave in disinfectant (‚sterilizing solution‘) for longer than recommended, as this may weaken the teat. Do not place in a heated oven.

Glass natural bottle
Glass bottles may break. Do not use metal inside the bottle to stir contents or for cleaning. This can damage the glass on the inside of the bottle. Before each use, inspect bottles for sharp edges or glass fragments inside. Do not use bottles if there are any cracks on or glass fragments in the bottle. Do not let babies drink unsupervised with this bottle. Do not use handles with glass bottles.
Choosing the right teat for your baby
The Philips Avant teats are available with different flow rates to help your baby with drinking. Over time you can change the teat accommodating the individual needs of your baby. Philips Avant teats are clearly numbered on the side to indicate flow rate (see image). Make sure you use a teat with the correct flow rate when you feed your baby. Use a lower flow rate if your baby chokes, is leaking milk or has trouble adjusting to the drinking speed. Use a higher flow rate if your baby falls asleep during feeding, gets frustrated or when feeding takes a very long time.
These Philips Avant teats can be used on the Natural Philips Avant feeding bottle and Philips Avant storage cups. Teats are available for 0m, 0m+, 1m+, 3m+, 6m+ variable flow (I/II/II) and thick feed (Y).
(0)The teat for 0m can be used from day one.
Extra soft silicone teat and it is the lowest flow rate available. Ideal for newborn and breastfed babies of all ages. The teat only has one opening for fluids and the number 0 is shown on the teat.

The teat for 0m+ has an extra soft silicone teat. Ideal for newborn and breastfed babies of all ages. The teat has only one opening for fluid and the number 1 is shown on the teat.
The teat for 1m+ has an extra soft silicone teat. Ideal for breastfed babies of all ages. The teat has two openings for fluid and the number 2 is shown on the teat.
The teat for 3m+ has an extra soft silicone teat. For bottle fed babies at 3 months of age and up. The teat has three openings for fluid and the number 3 is shown on the teat.
The teat for 6m+ has a bite resistant silicone teat. The sturdier teat is ideal for bottle fed babies at 4 months of age and up. The teat has four openings for fluid and the number 4 is shown on the teat.
(I/II/III) Variable flow: has a bite resistant silicone teat. The sturdier teat, with an adjustable flow rate to babies convenience is ideal for bottle fed babies at 3 months of age and up. The teat has one slot cut on the top for fluid and the markings I, II, III on the edges of the teat.

(Y) Thick feed: has a bite resistant silicone teat.
The sturdier teat, designed for thicker feeds is ideal for bottle fed babies at 6 months of age and up. The teat has one Y cut for fluid and the symbol Y on the teat.
Note: Every baby is unique and your baby‘s individual needs may vary from the description of flow rates.
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details).

Compatibility

– Spare teats are available separately.
Make sure you use a teat with the correct flow rate when you feed your baby (see ‚Choosing the right teat for your baby‘).
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Centre in your country.
– When you use an Philips Avant sterilizer, please check on the website how to place the Natural bottle.
– The high quality plastic Natural bottle is compatible with most Philips Avant breast pumps, spouts, sealing discs and cup tops.
– The glass Natural bottle is compatible with Philips Avant breast pumps and sealing discs. For safety reasons, it is not recommended to use glass Natural bottles with handles, spouts and cup tops and spouts. If the bottle falls, it may break.

www.philips.com/avent
Philips Consumer Lifestyle BV
Tussendiepen 4, 9206 AD Dakuten, Netherlands
Trademarks owned by the Philips Group.
©2017 Koninklijke Philips N.V. All rights reserved
4213.354.3864.4 FSC
www.philips.com