Numatic NX300 Charger Batterie Lithium Instruction Manual

Numatic NX300 Charger Batterie Lithium

ORIGINAL INSTRUCTIONS

ALWAYS READ AND OBSERVE THE INSTRUCTION MANUAL OF THE NUMATIC BATTERY UTILISING THIS CHARGER

Charging LED

Battery Charger State of Charge Indicator ( SoC)

No Battery Connected| Green Flashing Light
Charging| Red Light
80% Charged| Green Light
Error Condition / Battery Over Temperature| Red Flashing Light

Read all these warnings before using the charger.
Provide adequate ventilation during charging.

CAUTION! Charge only Numatic Lithium-Ion batteries, other types of batteries may burst causing personal injury and damage.

• Do not use damaged devices.
• Do not use the charger if it is wet.
• Do not charge below +5°C.
• Do not operate charger in explosive environment.
• Do not carry the charger by holding the mains cord.
• Do not handle the electrical cord or plug, with wet hands.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not cover the charger.
• Do not open the charger. Repairs shall be done only by authorised personnel.
• Do not charge damaged batteries.
• Do only charge dry batteries.
• Do not charge non-rechargeable batteries in this charger.
• Protect the charger against moisture and store it in a dry place.
• This appliance must not to be used by children or infirmed persons with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction.
• The mains voltage available must correspond to the voltage stated on the rating plate of the charger.
• Check the mains cord regularly for any sign of damage.
• If the mains cord of the charger is damaged, it must be replaced by an original NUMATIC INTERNATIONAL cord available from the manufacturer or service agent.

Instructions for Use – Charging the Battery

• The charger is intended for use only on flat surfaces, place horizontally on floor or work surface.
• The charger is intended for use with the power cord supplied, the power unit is capable of operating at different voltages without user adjustment.
• If your charger is fitted with a non-detachable cable this can only be changed by an authorized service partner.
• Make sure cable replacements are a genuine Numatic service part.
• If the charger is damaged or does not charge anymore, do not use, and contact your supplier.

Charging Procedure

|

1. Ensure the battery is fully inserted into the charger.
2. Fit the mains power cord to charger and suitable power supply.
3. Charger status lights table.

|
---|---|---

Charger Disposal

• This product must not be disposed of with domestic waste.
• This product must be disposed at an authorised recycling centre.
• By collecting and recycling waste you help save natural resources.

Numatic international Ltd.
Address: Millfield Road, Chard, Somerset, England.
Post code: TA20 2GB
Tel: +44 (0)1460 68480
Web Site: www.numatic.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>