Vallox 90 MV Ventilation Unit User Guide

Model
Vallox 90 MV
Vallox 90K MV| Document
D10811
---|---
Type
A3527 A3528| Valid from
01.01.2022
Updated
28.10.2021

WARNING
The unit is not intended for use by children under 8 or by persons with reduced sensory, physical or mental capabilities, or whose lack of knowledge and experience do not ensure safe operation of the unit. Such persons can use the unit under supervision, or by following the instructions of someone who is responsible for their safety.
Children must be supervised and not be allowed to play with the device.
DANGER
Indicates a hazard that will result in death or serious injury if not avoided.
WARNING
Indicates a hazard that can result in death or serious injury if not avoided.
CAUTION
Indicates a hazard that can result in minor or moderate injury if not avoided.
WARNING
Water must at all times be kept out of the electrical system

MAIN PARTS

Vallox 90 MV

1. extract fan

2. supply air fan

3. supply air fine filter

4. heat recovery cell

5. cell bypass flap

6. Supply air coarse filter

7. Extract air coarse filter

8. Post-heating resistor

9. Safety switch
   Vallox 90K MV
   
   

10. Internal humidity sensor
    10   Internal carbon dioxide sensor

11.   Control panel

12.  Carbon dioxide sensor (option)

13. Humidity sensor (option)

14. VOC-sensor (option)

15. Cooker hood

16.  Damper button

17. Fan speed adjustment

MOUNTING ON THE WALL

NSTALLING THE COOKER HOOD

ONDENSING WATER SEAL

DIMENSIONS AND OUTLETS

1. Supply air from the unit to the apartment
2.  Extract air from the apartment to the unit
3. Outdoor air to the unit
4.  Exhaust air flowing outdoors from the unit

FILTER

https://filters.vallox.com

HEAT RECOVERY CELL

FANS

FAN POWER CONSUMPTION

SUPPLY- AND EXTRACT AIRFLOW

extract air FIN poistoilma
supply air FIN tuloilma SWE tilluft

INTERNAL WIRING

Vallox 90MV

CABLE COLORS

A ENG Motherboard

1. ENG Extract fan tacho (WM)
2. GND (GN)
3. ENG Extract fan PWM (YE)
4. ENG Supply fan PWM (YE)
5. ENG Exhaust air
6. ENG Supply air

D LAN

INTERNAL WIRING

Vallox 90K MV

CABLE COLORS

Extract fan tacho (WM)
B| Extract fan PWM (YE)
Supply fan tacho (WT)
c| Supply fan PWM (YE)
Extract air
outdoor air
Supply air
Exhaust air
Supply air from the HR cell
D| LAN
E|  Hood connector
F| Vallox 90K MV Hood
MB_A| External Modbus A signal
MB_B| External Modbus B signal
+24V| +24V voltage (DC)
GND| Digital and analog ground potential
RS_A| Local hardware Modbus A signal
RS_B| Local hardware Modbus B signal
NTC| External temperature sensor connector
D/I1| Digital input
D/I2| Digital input 2
11V1| 11.1 V operating voltage
AN/I| Analog input 0-10VDC
RM/I| 24V relay input
RM/O| 24V relay output
T| Supply air fan
P|  Extract air fan
M| Damper motor LM230
TK| Safety switch
AHS| Safety switch
S/E| Post-heating control
RH% CO2|  Internal humidity and carbon dioxide sensor
R1| Post-heating resistor with 90°C and 130°C overheating protection

EXTERNAL WIRING DIAGRAM

* Ʃ = max. 6 W

1. MyVallox RH% sensor
2. Remote monitoring Modbus RTU
3. MyVallox CO2 sensor
4.  External temperature sensor
5. Analog input two different functions
6. Digital input 1
7. Digital input 2
8. Potential-free relay output
9. Ethernet-connector
10. RJ45 female
11. Ventilation unit internal electrical connections
12.  Plug connection 1.2 m on top of the unit

DECLARATION OF CONFORMITY

Manufacturer Vallox Oy
Address Myllykylantie 9-11, FIN-32200 LOIMAA, FINLAND 
Telephone number +358 10 7732 200
Fax +358 10 7732 201
The person who Petri Koivunen
compiles Vallox Oy
the technical file Myllykylantie 9-11, FIN-32200 LOIMAA, FINLAND
Tel. +358 10 7732 234
Fax +358 10 7732 201
Email petri.koivunenevallox.com
Description of unit Ventilation unit with heat recovery
Model Vallox 51 MV R, Vallox 51 MV L, Vallox 51K MV R, Vallox 51K MV L, Vallox 51 SC R, Vallox 51 SC L, Vallox 51K SC R, Vallox 51K SC L, ValloPlus 180 MV R, ValloPlus 180 MV L, ValloPlus 180 MV-K R, ValloPlus 180 MV-K L, ValloPlus 180 MV-E R, ValloPlus 180 MV-E L, ValloPlus 180 SC R, ValloPlus 180 SC L, Vallox 90 MC R, Vallox 90 MC L, Vallox 90K MC R, Vallox 90K MC L, Vallox 90 MV R, Vallox 90 MV L, Vallox 90K MV R. Vallox 90K MV L, ValloPlus 240 MV R, ValloPlus 240 MV L, ValloPlus 240K MV R, ValloPlus 240K MV L, ValloPlus 240 SC R, ValloPlus 240 SC L, Vallox 096 MC R, Vallox 096 MC L, Vallox 096 MV R, Vallox 096 MV L, ValloPlus 270 SC R, ValloPlus 270 SC L, ValloPlus 270 MV R, ValloPlus 270 MV L, Vallox 101 MC R, Vallox 101 MC L, Vallox 101 MV R. Vallox 101 MV L, Vallox 110 MV R, Vallox 110 MV L, ValloPlus 350 SC R. ValloPlus 350 SC L, ValloPlus 350 MV R, ValloPlus 350 MV L, Vallox 145 MV R, Vallox 145 MV L, ValloPlus 510 SC R, ValloPlus 510 SC L, ValloPlus 510 MV R, ValloPlus 510 MV L, Vallox 99 MV R, Vallox 99 MV L

Declares that the ventilation unit for supply and extract air, equipped with heat recovery and operating as part of a ventilation system has been designed and manufactured to the following specifications:

1. Low Voltage Directive (2014/35/EU) – EN 60335-1:2012 + A11:2014, A13:2017 + A1:2919 + A14:2019 + A2:2019; EN 62233:2008
2. EMC Directive (2014/30/EU) – EN 61000-6-1:2007, EN 61000-3-2:2014 + A1:2009 + A2:2009, EN 61000-3-3:2013, EN 61000-6-3:2007 + A1:2011
3. Ecodesign Directive (2009/125/EY) – Comission regulation 1253/2014 – EN 13141-7 Annex B, EN 308, EN 13141-7, ISO 3741, ISO 5135
   This is the original Declaration of Conformity
   Loimaa, 8th October 2021 I

Vallox Oy Myllykylantie 9-11 FI-32200 LOIMAA FINLAND
Tel. +358 10 7732 200 ALV rek.IVAT F106723509
Fax. +358 10 7732 201 Y-tunnus I Business
ID: 0672350-9 www.vallox.com
KotipaikkalRegistered Domicile:
Loimaa, Finland firstname.familyname@vallox.com

WARRANTY TERMS

1. SCOPE
   1.1 These warranty terms are applied to all products (“Products” or “the Product”) sold by Vallox Oy (“the Seller”) to its customers (“the Buyer”). Any deviations from these warranty terms must be agreed upon in writing.
   1.2 Any deviations from these warranty terms must be agreed upon in writing. These warranty terms supplement the separate contract made between the Seller and the Buyer (“the Contract”) and constitute a vital part of the said Contract. Should there be discrepancies between the Contract and these warranty terms, the terms and conditions of the Contract shall be applied instead of these warranty terms.

2. WARRANTY
   2.1 The Seller grants the Products a twenty-four (24) month warranty calculated from the delivery of the Product, unless the Seller and the Buyer agree otherwise. The Seller’s warranty includes the assurance that the Products comply with the Seller’s valid product specifications applied to normal trade, unless otherwise has been agreed upon by the Seller and the Buyer in writing (“Product specifications”). The repair or replacement of a faulty product does not extend the warranty period of the Product.
   2.2 Faults include, for example, manufacturing and structural errors and other faults and defects that become evident during the warranty period and reduce the usability of the Product. However, the Seller will not be responsible for faults when the Seller can prove that the deviation in the quality or usability of the product from normal is likely to be due to a reason attributable to the Buyer. Such a reason can be, for example, non-compliance with the installation, operation, or maintenance instructions provided to the Buyer or other erroneous handling of the Product.
   2.3 When the warranty is broken, the only legal remedies available to the Buyer and the only obligations of the Seller, subject to the sole discretion of the Seller, are: (i) compensating the purchase price in exchange for the return of the faulty Product, or (ii) repairing the Product or replacing the faulty Product with a new one.
   2.4 Repairing the Product or replacing the faulty Product with a new one requires, in accordance with these warranty terms, that the Seller or the party authorised by the Seller is given access to the premises and the systems to the extent required by the warranty servicing. If this requirement is not fulfilled and the warranty servicing cannot be implemented, the Buyer will be responsible for any resulting additional expenses.
   2.5 The Buyer must inspect the Products immediately upon reception and must submit a written claim to the Seller if the Products deviate from the Product specifications or are defective in relation to the Product specifications. A claim must be submitted on deviations and defects within fourteen (14) days from the moment they were observed or should have been observed. The claim must include a complete list of the Products that the Buyer considers to be faulty and detailed photographs of the faults. The model and serial number of the Products must be specified. Before the Seller accepts the warranty claim subject to the Seller’s sole discretion, the Seller has the right to inspect the faulty Products and the operating conditions in which the defects were observed. A claim must be submitted to the Seller of any hidden defects within fourteen (14) days from the moment they were observed or should have been observed. The Buyer has the burden of proving that the defect is hidden in nature.
   2.6 The Seller will not be responsible for any other fees or expenses based on the warranty. The faulty product that has been replaced must be handed over to the possession and ownership of the Seller. If Products must be returned to the Seller, the Seller reserves the right to approve the transportation expenses beforehand.
   2.7 If Products are suspected to be faulty or to not comply with the Product specifications, even when no fault has been identified, their use is strictly forbidden.
   2.8 The Seller will not be responsible for the product or a part of the Product when a) the Product is damaged during transportation, which the Seller is not responsible for based on the delivery term; b) the Product is damaged due to an accident after delivery or due to carelessness or inappropriate storage; c) the Product is used against the installation, operation, or maintenance instructions or otherwise in an inappropriate manner, or the use of the Product is continued despite poor performance; or d) the matter concerns normal tear and wear. If the Buyer neglects the above duty of care, the Buyer will be deemed to have waved all claims they have made regarding the Products.
   2.9 If it is found during warranty repairs that the Product is not faulty or that the fault is excluded from the scope of the warranty, the Seller has the right to charge a reasonable fee for the repair visit, even when no actual repairs are implemented.
   2.10 In addition to the warranty granted based on these warranty terms or the Contract, the Seller has not given any other explicit or silent warranty regarding e.g.
   the suitability for commercialisation or purpose of the Product. For the sake of clarity, it is stated that this warranty does not, therefore, cover the indirect losses or damage caused to the Buyer or any losses or damage caused to third parties by the faulty Product.

25.01.2022 | 500116

Vallox Oy
Myllykyläntie 9-11
FI-32200 LOIMAA | FINLAND| Tel. +358 10 7732 200
www.vallox.com| Y-tunnus 0672350-9
VAT no FI06723509| Registered domicile
Loimaa, Finland
---|---|---|---

www.vallox.com
Vallox Oy | Myllykyläntie 9-11
32200 LOIMAA | FINLAND
D10811/28.10.2022/PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>