HAGOR 8209 HP Twin Stand Installation Guide
- June 8, 2024
- HAGOR
Table of Contents
HAGOR 8209 HP Twin Stand
Caution!
Technical devices are of considerable value. You should therefore handle the
components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can
cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the
special conditions at the installation site. Please check this in advance and
replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions,
please contact us or other trained specialists.
Please note!
Tightening Direction
Loosening Direction
Screwdriver
Metre Rule
Adjustment
by Hand
HexWrench
Scope of delivery
ASSEMBLY
Make sure cabels management windows are facing the rear of base.
Use thumb or finger to depress the right upper pole spring plunger ball (1). Locted at the cable window, twist and pull upper pole upward until your desired height. As shown in the Picture on the left twist upper pole toward the plunger holes direction and engage the spring ball into the plunger hole (2). Repeat this for other pole (3 | 4). Tighten the locking screws on both sides as shown in the Picture on the right side.
Optional
Please note:
To avoid damage plastic spacer must be used when depth of mounting holes is
minimal.
Please note: Be caution when routing wires to avoid damage.
Dimensions
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: hagor@hagor.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>